GE BRIVO MR355, Service Training, Page: 217 / 227

GE Healthcare MR5047 SV Lab Guide
Page: 23 of 24
13. MCR III Tool Lab
Description:
This lab will familiarize the student with the MCR3 tool hardware setup
for Port A and Express PA coil, and software usage.
Time Required:
1 Hour
Learning
Objective(s):

Navigate the service documentation

Set up the hardware connection for Port A and Express PA coil

Know how to run the software and read the test result
Support Materials
Required:
Service Methods procedures 5364191 on disk, or as loaded onto
system computer. Refer to MCR III Tool for MR355/360.
( http://3.28.123.26:8000/mr/cdrom/5364191-
2EN/root/data/Signa_EXCITE/content/1084956.htm )
Tools Required:

MCR III Tool

Express PA Coil RF Cable Assy for MCR III Tool

Express PA Coil DC Cable Assy for MCR III Tool
Safety
Considerations:
Strong Magnetic Field! Ferrous materials can become dangerous
projectiles in the presence of the magnetic field Produced by the
Signa Magnet. Do not Bring any ferromagnetic tools or equipment
into the magnet room.
Steps: 1. MCR III Diagnostic
Use documented procedure in Direction 5364191:
Troubleshooting / Image Quality Troubleshooting Tools / MCR
III Tool for Optima MR360 / Brivo MR355
a. Perform Port A, Express PA coil test
Questions:
1. What is the function of the two-pin connector?
__________________________________________________
Review:
Questions for instructor:
______________________________________________________
______________________________________________________
______________________________________________________