4. Attach the filler panel to the
face of the window stop molding by
driving upholsterers’ tacks through
the holes in the filler panel flange.
Holes in
Flange
5. Pull the sliders out until the
sliders contact the face of the
window stop molding.
6. Pull the bottom window sash
down tightly and lock it in place by
installing a Type A screw through
the hole in the slider into the
window sash.
4.
into Cabinet.
1. Slide the chassis into the cabinet
and insert the line cord into the
notch in the cabinet. Make sure the
front of the chassis is flush with the
front of the cabinet.
Cord
Notches
2. Cut the plastic foam seal to the
proper length and insert it between
the upper and lower window sash.
3. If after installing unit back into
cabinet there is an air gap between
the unit and window sill, use the
extra PLASTIC FOAM SEAL to
the opening.
5.
Reinstall shipping
brackets for security
purposes.
6.
Dial Plate and
Control
7.
Air Filter and
Front Grille.
See page 5.
Instillation in Window
Openings 24%” Wide
●
all instructions on pages
6-8 except steps through 6 on
page 8.
●
Use foam seal to
any opening,
between the sides of the cabinet
and the window stop molding.
Instillation Other Than
Flush Mounting
In order to install the appliance
with more of it projecting into
the room, it will be necessary to
relocate the top retaining bar and
the bottom tie bar.
1. Check to make sure the
side louvers will not be blocked
when the unit is moved farther into
the room.
2. Remove the top retainer bar,
cabinet side seals and bottom tie
bar from the cabinet. Relocate
for the desired projection into the
room.
3. Using the top retaining bar and
cabinet side seals as templates,
locate and drill five 7/32”
holes in the top of the cabinet and
three on each cabinet side.
Retainer Bar
71321 Mounting
\
Holes
Tie Bar
4. Use sealing material (furnished)
to fill the holes in the cabinet top
and cabinet sides that became
exposed when the top retaining bar
and cabinet side seals were
relocated.
5. Follow all instructions on pages
6 through 8.
.
