Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Storm Window Requirements
A storm window frame will not allow the air
conditioner to tilt towards the outside and will keep
it from draining properly. To adjust for this, attach
a piece of wood to the stool.
WOOD PIECES—
WIDTH:
2
″
LENGTH:
Long enough to fit inside the window
frame.
THICKNESS:
To determine the thickness, place a
piece of wood on the stool to make it 1/2
″
higher
than the top of the storm window frame.
Attach securely with nails or screws provided by
the installer.
2
Read completely, then follow step-by-step.
1/2
″
higher
than frame
Storm window
frame
Wood
Stool
Remove the Front Grille, if attached
To remove the grille:
Remove shipping tape if present.
On models with a slide out air filter, remove
it (see the Care and Cleaning section) and
the screw behind it (if present) that holds
the grille in place.
On models with a raise up inlet grille, lift it
(see the Care and Cleaning section) and
remove the screw behind it (if present) that
holds the grille in place.
A
Pull the bottom grille corners out to release
the lower tabs on each side.
B
NOTE:
Do not pull the bottom edge toward you more
than 3 inches or you may damage the tabs of the grille.
Lift the grille
up and off the
top tabs.
C
3
11
Window Requirements
■
These instructions are for a standard double-
hung window. You will need to modify them for
other types of windows.
■
The air conditioner can be installed without
the accordion panels if needed to fit in a narrow
window. See the window opening dimensions
at right.
■
All supporting parts must be secured to firm
wood, masonry or metal.
■
The electrical outlet must be within reach of the
power cord.
1
17
3
⁄
8
″
min.
30
″
to 41
″
(With accordion panels)
26
″
min.
(Without accordion panels)
