13
Panel Version
¾
To display the panel version:
1. Press
until you see VERSION.
2. Press .
The current panel version is displayed.
Phone Module Version
¾
To display the phone module version:
1. Press
until you see PHONE MODULE.
2. Press
once
and then to display the current phone module version.
Testing the
System
You should test the system periodically. The system contains a test mode that allows you to test
sensors without creating false alarms in monitored systems.
Refer to “Appendix A: Troubleshooting” on page 16 if correct test results are not achieved.
Automatic Test Features
Your security system conducts routine tests, checking for problems like power failures, low bat-
teries, sensors that aren’t working, and communication trouble with the central monitoring sta-
tion.
When your system detects a problem, trouble beeps sound to alert you. See “Trouble Beeps and
Trouble Messages” on page 14 and “Trouble Beeps” on page 22 for an explanation of the causes
of trouble beeps and what you can do to fix the problem.
Manual Tests
There are also weekly system tests you can do yourself as an added safeguard. Taking time to do
these tests will familiarize you with your system and alert you to anything unusual, such as sen-
sors that have been tampered with.
Sensor Test
This test verifies that the sensors in your system are operating correctly. We recommend that you
test sensors/zones once weekly.
• DTIM and battery tests are performed at the start of the sensor test. The panel will display the
DTIM zone number and beep once for every received transmission.
• The panel will beep indicating the number of transmissions received, (see Table 6: Sensor
“Tripping” Instructions), and display
<
SENSOR
NAME
>
+
OK
to indicate the panel heard from the
sensor. For the first 10 to 20 seconds of test, the volume is set to a lower level.
• Panel will automatically leave sensor test after 15 minutes.
• To extend a sensor test, or restart the sensor list, press 1. This also restarts the 15 minute
timer.
• The panel will display
TEST
DONE
when all sensors have been tested.
¾
To perform a sensor test:
1. Press
until you see sensor test.
2. Press . The display scrolls through untested zones, and beeps to indicate successful
sensor packets. Count the number of beeps and refer to Table 6 for the number required.
3. Trip each sensor. (Open door or window)
The panel will display
TEST
DONE
when all sensors have been tested.
