GE 5661242, Basic Service Manual

Page: 298 / 317

Care and Maintenance
10-22 LOGIQ V2/LOGIQ V1 – Basic Service Manual
5610739-100 English Rev.10
Leakage current limits
The following limits are summarized for IEC 60601-1 Medical
Equipment Safety Standards. These limits are GEMS standards
and in some cases are lower than the above standards listed.
WARNING
Energy Control and Power Lockout for LOGIQ V2/LOGIQ V1.
When servicing parts of the Ultrasound system where there is
exposure to voltage greater than 30 volts:
1. Follow LOCK OUT/TAG OUT procedures.
2. Turn off the breaker.
3. Unplug the Ultrasound system.
4. Maintain control of the Ultrasound system power plug.
5. Wait for at least 30 seconds for capacitors to discharge as
there are no test points to verify isolation.
6. Remove/disconnect the battery, if present.
Ultrasound System components may be energized.
CAUTION
Compare all safety-test results with safety-test results of
previously performed safety tests (e.g. last year etc). In case of
unexplainable abrupt changes of safety-test results consult
experienced authorized service personnel or GE for further
analysis.
Table 10-12: Chassis Leakage Current Limits - Accessible Metal Surface
Country
Normal
Condition Open Ground
Reverse
Polarity Open Neutral
All (Except USA &
Canada) 0.1 mA 0.5 mA 0.5 mA 0.5 mA
USA & Canada 0.1 mA 0.3 mA 0.3 mA 0.3 mA
Table 10-13: Type BF Applied Part Leakage Current Limits - Probes Surface
Country
Normal
Condition
Open
Ground
Reverse
Polarity
Open
Neutral
*Mains
Applied
All 0.1 mA 0.5 mA 0.5 mA 0.5 mA 5.0 mA