10
CAUTION:
Use only the ATLINKS USA, Inc. 5-2596 (black) and 5-2625
(gray color adapter for white unit) power supply that came with this unit.
Using other power supplies may damage the unit.
2. Plug the handset charge cradle into an electrical outlet.
NOTE:
The charge indicator on the handset charge cradle turns on to
indicate the handset battery is charging
Allow the handset to charge for 12 hours prior to first use. If you don't
properly charge the system, battery performance is compromised.
NOTE:
If the battery is not properly installed in the handset, or if the battery
pack is not properly connected to the jack inside the battery compartment,
“
NO BATTERY
” flashes in the display.
C
ONNECTING
THE
T
ELEPHONE
L
INE
On the base, plug one end of the straight telephone line cord into the jack on
the back of the base and the other end into a modular wall telephone jack.
NOTE:
If desired, gather the extra telephone line and power supply cord
together, fasten with a wire tie.
C
ONNECTING
THE
C
ORDED
H
ANDSET
1. Connect one end of the coiled handset cord to the jack on the side of
the base.
2. Connect the other end of the coiled cord to the jack on the handset, then
place the handset in the base cradle.
W
ALL
M
OUNTING
THE
B
ASE
The base is packaged with the pedestal attached in desktop mode. To
mount the base on the wall:
1. Turn the base over and remove the pedestal.
2. Rotate the pedestal a half turn, and align it with the bottom of the base.
3. Attach the pedestal by first inserting the tabs on the pedestal into the
slots on the bottom of the base, and then push the pedestal down until
it snaps into place.
