– 26 –
Control Panel Assembly
The control panel assembly consists of an outer
control panel and an inner control panel bracket.
The outer control panel contains the control, display,
and selector circuit boards. The power and relay
circuit boards, and the low voltage transformer are
attached to the control panel bracket.
The control panel is held in place with 7 Phillips-
head screws and 4 tabs. Two of the screws are
recessed from the top of the outer cover. Access
holes are provided. A magnetic screwdriver is
necessary to capture these screws.
To remove the control panel assembly:
Place the oven in a partially removed position.
1.
(See
Oven Removal / Partial Removal
.)
Remove the 3 Phillips-head screws from the top
2.
front of the outer cover.
3. Remove the 2 recessed Phillips-head screws
that attach the control panel assembly to the
top of the frame.
5. Open the oven door.
Grasp the bottom of the control panel assembly
6.
and lift to release the 2 tabs that hold the
bottom of the control panel assembly to the
oven frame.
Disconnect wire harnesses from the power
7.
board at locations CN5, CN6, CN7, CN8, and
CN9. (See
Control Boards and Panel Connections
.)
Disconnect wire harnesses from the relay board
8.
at locations RY7, RY9, RY11, RY12, and CN14.
(See
Control Boards and Panel Connections
.)
4. Remove the 2 Phillips-head screws that attach
the control panel assembly to the side of the
frame.
Relay Board
Power Board
