GE Security FireShield FS1004, Technical Reference Manual

Page: 37 / 68

Programming
FireShield Technical Reference Manual 3.15
Circuit programming
Circuit programming defines the routes and codes used to
report IDC and NAC events. Unless the options described
below are changed, the factory default event codes are sent to
CS 1 only. If the default selections are acceptable, you can
skip to “End programming” below.
Note:
IDC disabled and NAC disabled events are
automatically routed to the receiver you select for the IDC
trouble activation and NAC trouble activation events.
To program the circuits, you’ll follow these general steps:
1. Select the receiver for each IDC event
2. Select the receiver for each NAC trouble event
3. Set up or change system event codes
4. Set up or change IDC event codes
5. Set up or change the IDC zone restoration code
6. Set up or change the NAC trouble code
7. Set up or change the NAC trouble restoration code
8. End
programming
1. Select the receiver for each IDC event
Description: Determines where alarm, waterflow, trouble,
supervisory, and monitor IDC events are reported.
An IDC has five possible events. You only need to program
those events that apply to the
zone type of the selected IDC.
For example, if the IDC is configured as alarm-verified (or
alarm-unverified) you only need to configure the alarm and
trouble events. You don’t need to select a receiver for the
waterflow, supervisory, or monitor events for that IDC.
The following table lists the events that apply to each zone
type.
Event types
Zone type Alarm Waterflow Trouble Supervisory Monitor
Alarm X X
Waterflow X X
Waterflow /
Supervisory X X X
Supervisory X X
Monitor X X
Settings: None
CS
1
CS 2
CS 1 and 2
Default: CS 1
To select the receiver for each IDC event:
1. Select an IDC for programming by pressing the Disable
button for that IDC.
2. Determine the zone type assigned to the selected IDC.
Refer to the “Panel programming worksheet” you
completed.
3. Use the table shown above to determine which event
types need to be configured.
4. Press Remote Disconnect or Walk Test to select the
desired event type.
5. Press Reset to select the desired receiver.
6. Press Panel Silence to save the setting.
The trouble buzzer sounds a long beep as confirmation.
7. Repeat steps 4 and 5 for each event type you need to
configure.
8. Repeat steps 1 through 7 for each IDC you want to
program.
9. When the required IDCs have been programmed, press
Remote Disconnect to advance to the next program
option.
2. Select the receiver for each NAC trouble event
Description: Determines where an NAC trouble event is
reported.
Note:
You must program each NAC during this step.
Settings: None
CS
1
CS 2
CS 1 and 2
Default: CS 1
To select the receiver for each NAC trouble event:
1. Select an NAC for programming by pressing the Disable
button for that NAC.
2. Press Reset to select the desired receivers.
3. Press Panel Silence to save the setting.
The trouble buzzer sounds a long beep as confirmation.
4. Repeat steps 1 through 3 for each NAC you want to
program.
5. When all NACs have been programmed, press Remote
Disconnect to advance to the next program option.
3. Set up or change system event codes
Description: Defines the 4/2 event codes (reset, drill, trouble
silence, etc.) that are sent to the CMS for system level events.