28
Mercury Reference Manual
05-4446A01, Rev. E
2.6.1 Option Set 1 Connectors
Figure 2-4
shows the interface connectors on the front panel of the
Option Set 1 Remote transceiver.
NOTE:
The use of shielded Ethernet cable is recommended for
connection to the radio’s
ETH
port. The radio meets regulatory
emission standards without shielded cable, but shielding
reduces the possibility of interference in sensitive environ-
ments, and is in keeping with good engineering practice.
Invisible place holder
Figure 2-4. Option Set 1 Transceiver
Interface Connectors
•
LED INDICATOR PANEL
—Displays the basic operating status of
the transceiver. See section
2.7
on Page 29 for detailed informa-
tion.
•
COM1 SERIAL PORT
— DB-9 connector used for management
of the transceiver with a connected PC.
INTRODUCTION on
Page 33
provides complete connection details.
•
LAN PORTS
—Connection point for Ethernet Local Area Net-
work. The connectors have integrated LEDs to indicate signal
activity as follows: A steady green LED indicates that a link has
been achieved; a flashing green LED indicates data activity; and
a yellow LED indicates 100 Mbps operation.
•
PWR
— DC power connection for the transceiver. Power source
must be 10 Vdc to 30 Vdc, negative ground, and capable of pro-
viding at least 25 watts.
Summary of Contents for Mercury 900
