
Care and Cleaning
Stainless Steel Gas Range
22
Porcelain
interior
With proper care, the porcelain enamel finish
on the inside of the oven—top, bottom, sides,
back and inside of the door—will stay new-
looking for years.
Let the range cool before cleaning.
We
recommend that you wear rubber gloves when
cleaning the range.
Soap and water will normally do the job.
Heavy
spattering or spillovers may require cleaning
with a mild abrasive cleaner. Soapy, wet metal
pads may also be used. Do not allow food spills
with a high sugar or acid content (such as
tomatoes, sauerkraut, fruit juices or pie filling)
to remain on the surface. They may cause a
dull spot even after cleaning.
Household ammonia may make the cleaning
job easier.
Place 1/2 cup in a shallow glass or
pottery container in a cold oven overnight.
The ammonia fumes will help loosen the
burned-on grease and food.
If necessary, you may use an oven cleaner.
Follow the package directions.
Cautions about using spray-on oven cleaners:
• Do not allow a film from the cleaner to build
up on the temperature sensor—it could cause
the oven to heat improperly. (The sensor is
located at the top of the oven.) Carefully wipe
the sensor clean after each oven cleaning,
being careful not to move the sensor as a
change in its position could affect how the
oven bakes.
• Do not spray any oven cleaner on the oven
door, handles or any exterior surface of the
oven, cabinets or painted surfaces.
The cleaner can damage these surfaces.
Oven
shelf slide
assembly
To remove the slide assemblies:
1
Loosen the retaining screws on both sides of
the oven.
2
Lift up slightly and pull the entire assembly
out. Set aside.
To replace the slide assemblies:
1
Guide the rear of the shelf slide assembly into
the bottom rear bracket.
2
Guide the top rear of the shelf slide assembly
into the top “U”-shaped bracket.
3
Lift up the push rod so that it rests on the
ledge of the side support of the assembly.
4
Reattach the assembly securely to the oven
with the retaining screw. Repeat for the other
side of the oven.
Retaining
screw
Push up here
Bottom
bracket
Lift up and off
U-Shaped
bracket
Push
rod
Pull the entire assembly out.