4
5
Due to constant improvements to and further developments of our designs, the information and illustrations in this brochure are non-binding.
The specifications and mounted lengths provided by the machine manufacturer must be observed. All specifications are in mm.
Instruction manual
μGrind Nann 3409E
Instruction manual
μGrind Nann 3409E
1.
Clean all contact surfaces of the chuck.
2.
Assure cleanliness and planarity of machine
interface.
3.
The µGrind chuck needs to be at room temperature.
1.
Screw the included push rod (2) hand-tight into your
machine spindle.
2.
Remove the swarf guard by turning according to the
marking into OPEN position.
3.
Use machine control to move pushrod into backward
position.
Step 2:
Step 1:
Preparation
Druckstange einschrauben
1.
Loosen the adjustment screws.
2.
Mount the µGrind chuck on the spindle face using
the wrench (4). SLIGHTLY tighten the mounting
screws. They will be tightened later, when adjusting
the run-out.
Step 3:
Mount µGrind Chuck
Wrench
Test pin
Dial gauges
Swarf guard
Clamping sleeve
Adjustment screw
Mounting screw
Push rod
Adjustment hammer
IMPORTANT:
move push rod into backward
position before mounting the µGrind chuck.
4 mounting screws
4 adjustment screws
Only use the push rod labeled "System
Walter SK50 μGrind Booster" for this
chuck.
Important:
Push rod is in
backward position.
