6
Electrical Connections
Supply
A,N,E 240v 3A fused input terminals are provided pre wired with a 3 pin plug top.
Supply transformer rated at 240vac primary, 24vac 160VA secondary.
A 20A Blade fuse is fitted on the board. (this fuse rating must not be exceeded, doing so will void warranty)
Power for accessories
12v dc 250 ma regulated supply available at the control board terminals.
Or regulated 24vdc 1A supply located on DIN rail, protected by a replaceable 20mm glass fuse.
Control Board
(Refer to the Elsema MCSv2 manual for full details)
The control board uses Elsema`s Eclipse operating system and has been pre-set and test run in the factory
with settings which are a general setting for a mid- sized gate. Settings can be changed to suit the individual
installation through the menu system. If the board has to be reset at any time, or the motor speed altered, the
screen will prompt you to
perform the “I learn” procedure.
Control Inputs
M1 motor limits
: pre wired and factory set for a n/c connection.
Push button
: N/o input acts as a OSC (open, stop, close) input.
Open
: N/o input acts as a open only (swipe mode) input.
Close
: N/o input close only input (force close) input.
Ped Access
: Used for initiating a partial opening.
Photo Beam (P.E) : N/C safety input. Can be set for n/o operation if needed through menu 3.1.
PE beam operation modes can be changed through menu 4.2.
Control Outputs
Motor 1
:
Power output to motor 1. Polarity doesn’t matter as motor direction can be checked
and changed through the initial I learn set up procedure.
12v dc
: Supplies regulated 12v dc at a max of 250 ma, can be used for accessories such as pe
cells warning devices etc, but must not exceed 250ma.
24v dc
: Supplies 24v dc 1.0A regulated output, this can be used for higher power usage devices
such as induction loops. This output is fused at 1.0 A.
Output 1
: N/o dry contact relay output. Do not exceed 5A load. Can be set for various functions
through menu 5.1 default is Lock/Brake.
Output 2
: N/o plus n/c dry contact relay output, 5A max. Functions set through menu 5.2 factory
default is courtesy light.
Battery
: An on-board charger is provided. SLA batteries can be connected directly to these
terminals. The batteries not only provide a limited number of operations in a power
outage, they also provide extra current for the motor to draw upon if needed. It is
important to change the batteries when they get to the end of their life, which generally
is 2 to 3 years, but there is a lot of varying factors which affect battery life.
A Maximum of 12 AHR battery capacity may be connected.
