3
To commission the gate, move the gate approximately 1m
from the fully open position and tighten the knurled wheel
(Clockwise) engaging the clutch assembly
Press the opening button located under the dip switches to
begin opening cycle,
Ensure
the direction the gate travels is in accordance with the
opening and closing status LED’s, if not reverse two of the
motor wires at the inverter terminals.
Inverter settings can be adjusted via the keypad i.e. Opening
speed, closing speed and ramp times. Automation settings
operating modes are able to be adjusted via the CB6 board, refer
to manual for further instructions
Once Inverter settings are appropriately set proceed to fine
adjust the Limits for required operation
Summary of Contents for 450L
Page 7: ...7 Operator Dimensions ...
Page 12: ......
