DU-RS-0006-64 Rev B 3/28/14 GCX Corp Page 3 of 5
Installing Basket on Post
1. Above the reinforcing bar (below left), install Nylon Clips at an angle, in center of Basket. Rotate Clips until both are
horizontal. Slide Clips to top and bottom of Basket.
2. Slide Clips over top end of Post. Position Basket at desired height and install two (2) #8-32 pan head machine screws
(PHMS) and #8-32 hex nuts as shown below. Tighten screws until Basket does not rotate on Post.
Installing Mounting Plate Assembly in Post
1. Insert Mounting Plate Assembly in top of Post (below left). Press downward while twisting until the Assembly snaps
into place. Swivel the Mounting Plate until the spring-loaded plunger is toward
the front of the Roll Stand.
Mounting Plate Assembly
Plunger toward Front
#8-32 Hex Nuts (2)
Slide Basket over End of Post
#8-32 x 1-1/2'' PHMS (2)
Reinforcing Bar
