DU-AG-0021-100 Rev A 4/15/08 GCX Corp. Page 5 of 6
Swiveling the Mounted Instrument
Grasp the sides of the instrument and swivel to desired position. Note: Swivel is limited to ± 20º on this Mount.
Adjusting Tilt and Tilt Tension
Tilt:
Grasp the top and bottom of the instrument and tilt it to desired angle.
Tilt Tension:
Using the 5/32'' hex wrench provided, equally tighten or
loosen the two (2) Tilt Tension Screws.
Mounting Horizontal Mount in Channel
The following parts and hardware are included in this installation kit (hardware not shown):
Tools Required
• Phillips screwdriver
1. Fasten the Philips-supplied Table Top Mount to the Mounting Adapter with three (3) M6 x 10mm PHMS as shown below.
2. With two (2) set screws oriented toward rear of application, slide Horizontal Mount into Channel and move Mount to
desired instrument-mounting position (example below left).
3. Tighten two (2) Phillips-head set screws at rear of Horizontal Mount to prevent movement of Mount (below right). See
page 5 for photo of Horizontal Channel Mount installed on top of Fabius GS.
Item #
Description
Qty
1
Horizontal Channel Mount
1
2
M6 x 10mm Flat Head Machine Screw (FHMS)
3
Table Top Mount
(Supplied by Philips)
M6 X 10mm FHMS (3)
Horizontal Mount Adapter
Set Screws
(Rear of Mount)
Insert Horizontal Mount
In Channel
1
Tilt Tension Screws (2)
