www.GCCworld.com LABEL EXPRESS / DECAL EXPRESS User Manual
8
and operational smoke or fire detector should be kept in the vicinity of the
machine.
• Caution—Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
• Resulting debris from laser cutting are very dangerous and may cause fire hazard.
DO NOT leave debris and scraps inside laser machine after job finished. Always
keep machine clean after job finished.
• Always wear safety goggles when the laser system is in operation. Reflective
materials may partially-reflect some of the invisible laser radiation. Severe eye
damage may occur if proper safety goggles are not worn.
• Connect the machine to a properly grounded power outlet. Ensure the voltage of the
power source is identical to the voltage of the machine.
• Do not open the laser access panel when the machine is plugged in.
• Do not attempt to modify or disassemble the laser module.
• Do not attempt to remove or modify any component of the machine’s laser interlock
safety system.
WARNING
・
Resulting debris from laser processing are very dangerous and may cause fire
hazard.
・
DO NOT
leave debris and scraps inside laser machine after job finished. Must
keep machine clean after job finished.
NOTE
Each Laser machine is shipped with a single pair of safety goggles. If additional safety goggles
are required, please contact GCC directly or an authorized GCC distributor. If you wish to
purchase one on your own, please make sure the safety goggles meet these requirements:
9,300-10,600nm OD5+
Visible Light Transmission: 92.9%
