NEOSERV 114
gbo Medizintechnik AG 2004
Version 1.5
7
Standby key
Overtemperature
Vacuum pressure
Attention!
Observe user manual!
Water level
Pulse regulator
Vacuum regulator
Suction connectors
channel I
Suction connectors
channel I
Figure 3:
Front view
NEOSERV 114
Application part ungrounded, protection
degree BF
1. Connect
the
DUODYNATOR 119
with the connecting cable.
!!
Note!
At the combined operation with ultrasound you must additionally use the connection
cable „
NEOSERV
Ultrasound
“. Herewith you have to connect a suction connector of the
NEOSERV 114
to the stimulation current connection of the ultrasound therapy unit
(e.g.
,
SONOSTAT 135
).
2. Switch on the
NEOSERV 114
(switch located at the back of the device). The green LED of the
Standby key
will be flashing.
3. Connect all needed electrodes to the appropriate connectors by means of the electrode hoses
(red = channel I; green = channel II).
!!
Note!
•
If you use only 2 suction electrodes, you must close the suction connections of the unused
channel with the short circuit hose before operation.
•
While plugging the tube connections you must overcome 2 pressure points, otherwise the
suction connection is not airtight.
4. Press
the
Standby key
. The pump is working now and the unit is ready to be used.
5. Apply the suction electrodes.
6. Use the both rotary regulators to set parameters as desired:
•
Left control:
Pulses per minute
•
Right control: vacuum pressure
7. The suction electrodes may be removed or repositioned only after the electrostimulation treatment has
been terminated or interrupted (i.e., no stimulation current applied any longer).
8. To remove the suction electrodes, just lift the sealing ring.
