Operation
DS-60 Operation and Maintenance Manual
3-4
© GBC Pro-Tech 1998 January
6KHHW)HHG7UDQVIHU
1. See process chart 3-3 and diagram 3-3a.
2. Make sure the infeed idler assembly is in the low-
ered position.
3. Set the heater controller to operational temperature
and confirm that it is rotating with the lower main
roll.
4. Once the upper main roll is at operating tempera-
ture, center the craft paper on the unwind and
secure.
5. Stop the rolls from turning and raise the upper
main roll.
6. Web the craft paper through the machine all the
way to the rear lower unwind.
7. Pivot the idler assembly into its up position and
secure it.
8. Perform the transfer by inserting the materials into
the craft paper/main roll nip using the infeed table.
9. Start the heat press.
10. To stop the transfer, stop the machine, lower the
idler assembly, and raise the main roll. The web
can be left this way indefinitely.
11. Heat Press Roll Pressure: 40% maximum.
12. Speed: 1-4 fpm (30-90 cpm).
13. Upper Heat Press Roll Heat: 395 °F (200 °C) max-
imum.
Summary of Contents for PRO-TECH DS-60
Page 4: ...DS 60 Operation and Maintenance Manual iv GBC Pro Tech 1998 January Blank page ...
Page 16: ...Installation DS 60 Operation and Maintenance Manual 2 6 GBC Pro Tech 1998 January Blank page ...
Page 32: ...Warranty DS 60 Operation and Maintenance Manual 5 2 GBC Pro Tech 1998 January Blank page ...
Page 36: ...Index DS 60 Operation and Maintenance Manual 7 2 GBC Pro Tech 1998 January Blank page ...