![background image](http://html1.mh-extra.com/html/gbc/pro-tech-ds-60/pro-tech-ds-60_operation-and-maintenance-manual_571033017.webp)
DS-60 Operation and Maintenance Manual
Operation
© GBC Pro-Tech 1998 January
3-1
6HFWLRQ2SHUDWLRQ
6DIHW\
GBC Pro-Tech DS-60 Heat Press is a powerful
machine that is designed to perform dye sublimation.
The forces required to accomplish this task can vary
from negligible to very large.
In addition, the main roll of the DS-60 can reach tem-
peratures of 475
°
F (235
°
C). At these temperatures
there is a danger of a severe burn if the roll is touched
during set-up, operation or servicing.
The DS-60 Heat Press has a steel cabinet that is bolted
closed to isolate the electrical and drive system compo-
nents for the safety of the operator. Only a qualified
service technician should open these cabinets.
The heat press is equipped with four emergency stop
buttons located on the top front and back of either side
of the heat press. Any of these, if engaged, stops the
heat press. To continue operation all emergency stop
buttons must be in the up position and you must press
the reset button above the fuse panel on the back of the
heat press (see Figure 3-2).
Figure 3-1: Using the Emergency Stop Buttons
Figure 3-2: Resetting the Heat Press
NOT AUS
EM
E
R
G
E
N
CY
ST
OP
AR
RE
TD
'
U
R
G
E
N
CE
NOT AUS
EM
E
R
G
E
N
CY
ST
OP
AR
RE
TD
'
U
R
G
E
N
CE
1/4 turn
Twist each button
to resume
operation - the
button pops up
Push any button
to stop the
laminator
Reset Button
Summary of Contents for PRO-TECH DS-60
Page 4: ...DS 60 Operation and Maintenance Manual iv GBC Pro Tech 1998 January Blank page ...
Page 16: ...Installation DS 60 Operation and Maintenance Manual 2 6 GBC Pro Tech 1998 January Blank page ...
Page 32: ...Warranty DS 60 Operation and Maintenance Manual 5 2 GBC Pro Tech 1998 January Blank page ...
Page 36: ...Index DS 60 Operation and Maintenance Manual 7 2 GBC Pro Tech 1998 January Blank page ...