![background image](http://html1.mh-extra.com/html/gbc/pro-series/pro-series_instruction-manual_3861495006.webp)
6
Operation, cold lamination
1. Connect power cord to appropriate power source.
2. Press the power switch on the back of the laminator and press
the POWER button for 1 second to turn on the machine.
3. Press COLD button and “COLD” symbol appears on the LCD.
4. When the machine is ready to laminate, the laminator will beep
and the “READY” symbol appears on the LCD.
5. Use and laminate your cold pouch by pressing the STOP <RUN>
button to start or stop the roller.
CAUTION: If you have just done hot lamination, press COLD
button (to cool down machine) and wait for the “READY”
symbol to reappear on the LCD before attempting to do cold
lamination.
m
Reverse Button
In the event of a misfeed or a jam follow these instructions.
1. Press the REV button and hold down. This will reverse the
rotation of the rollers allowing the pouch to exit the front of the
machine.
2. Pull the document out of the laminator.
3. After the document is out of the machine clean the rollers by
running the cleaning sheet through the laminator.
CAUTION: Be careful when removing the laminated pouch
from the machine. It may be hot.
m
Operation, hot lamination
1. Connect power cord to appropriate power source.
2. Press the power switch on the back of the laminator and press the POWER button for 1 second to turn on the machine (fig. A).
3. Using the lamination guidelines, select the appropriate temperature setting for the pouch gauge thickness and material you are laminating.
• If the laminated item appears to be cloudy, it means that the laminator temperature is not hot enough. Allow the laminator to heat for a few
more minutes then run the pouch through again.
• If the laminated item is wavy, the TEMPERATURE is too hot. Verify temperature selector is set at the appropriate temperature.
• Always allow sufficient time for the laminator to adjust to changes in temperature setting.
4. As the machine warms up, the heating symbol (
) will flash. When the machine is ready to laminate, the laminator will beep and the
“READY” symbol appears on the LCD (fig. C).
5. Centre the item to be laminated within the pouch left to right with the top edge against the sealed edge of the pouch (fig. D).
6. Insert the pouch with the sealed edge first into the machine (fig. E).
7. The laminated item will automatically exit the rear of the machine. After the pouch has stopped moving, immediately place it on a flat surface
to cool for one minute before handling (fig. F).
a. Press HOT button to choose Preset
mode. Machine is set to temperature
100°C / speed 6 and “HOT” symbol
appears on the LCD. (fig. B).
a. Press the temperature Up/Down arrow
keys to modify the temperature setting.
b. Press the speed Up/Down arrow keys to
modify the speed setting.
a. Press either button 1 or 2 for one second
to enter memory mode.
b. Set your frequent use temperature and
speed setting using the Up/Down arrow
keys.
c. Press the number button again to save
setting to memory.
d. To use a saved memory, select either
button 1 or 2. The LCD will indicate the
temperature and speed selected.
1. Preset Mode
2. Manual Mode
(to change speed and temperature manually):
3. Memory Mode
(to save specific temperature and speed in memory):