![background image](http://html1.mh-extra.com/html/gbc/orca-iv/orca-iv_operation-manual_571027040.webp)
Maintenance and Troubleshooting
ORCA-IV Image Transfer Laminator Operation Manual
4-2
© GBC Pro-Tech 1998 October
To clean beads of adhesive, dust and dirt from the
rolls:
1. Allow the image transfer laminator to cool slightly
to no higher than 110ºF (43ºC).
2. Set the FWD/REV switch to the REV position and
let the rolls move slowly as you clean them. Set the
Speed Control to 1.5 ft/min.
3. Clean the rolls using a moderate amount of 80%
isopropyl alcohol on a cotton terry cloth.
IMPORTANT
IMPORTANT
IMPORTANT
To clean the cabinet and covers:
1. Using a damp cotton terry cloth (water only), clean
the exterior of the image transfer laminator.
WARNING
To clean the doors:
1. Using a cotton terry cloth, wash the doors using a
mild soap or detergent and lukewarm water.
IMPORTANT
2. Rinse thoroughly to prevent water spotting.
3. To remove grease, rub lightly with isopropyl alco-
hol, then wash and rinse.
Compatible Cleaning Agents:
•
Fantastik
1
•
Formula 409
1
•
Hexcel, F.O. 554
•
Joy
2
•
Lysol
3
•
Mr. Clean
2
•
Neleco-Placer
•
PineSol
4
•
Top Job
2
•
Windex
5
1
Registered Trademark of the Clorox Company.
2
Registered Trademarks of Procter & Gamble.
3
Registered Trademark of Sterling Drugs.
4
Registered Trademark of American Cyanamid.
5
Registered Trademark of the Drackett Products Company.
Use the minimum amount of pressure necessary
to clean the rolls. You can destroy the silicone
layer on the rolls by pressing to hard or
scrubbing too long in one spot.
Exercise care when cleaning the rolls with 80%
isopropyl alcohol:
•
Use only in a well ventilated area.
•
Wear rubber gloves.
•
Use only on cool rolls.
Cleaning heated rolls can ignite the fumes.
Use only 80% isopropyl alcohol or a rubber
cement eraser to clean the laminating rolls.
Harsh chemicals like toluene, acetone or MEK
destroy the silicone covering of the rolls.
Do not use liquid or aerosol cleaners on the image
transfer laminator. Do not spill liquid of any kind
on the image transfer laminator. You can be
severely shocked, electrocuted or cause a fire. Use
only a damp cloth for cleaning.
Do not scrub or use brushes or squeegees to clean
the doors. You can scratch the surface.