6. Operation
SETUP
A.
EDGE GUIDE ALIGNMENT
: Unlock the edge
guide by turning the knob counter clockwise,
slide the guide to the proper position based on
your paper size and lock the edge guide by
turning the knob clockwise.
B.
DIE INSERTION/REMOVAL
: If the die for the
desired punch pattern is not currently in the
machine, you need to replace it. To do this:
Turn machine off, then rotate the die
locking handle to the unlock position.
Remove the die by sliding it out
Insert the proper die and slide it in.
Rotate the die locking handle to the
locked position
C.
DIE PIN REMOVAL:
With die inserted and edge
guide at proper position place media on table
top against the edge guide.
Use die label to
determine if any pins should be removed. To
remove pins:
Remove die following steps above
Remove magnet resting on the pins of
the die.
Remove the pins by sliding them up
through the channel and store for use
later.
Replace the magnet and re-insert the
die
D.
TABLE TOP TRIGGER SETUP:
The punch can
operate in Foot Pedal mode or Table Top
trigger operation. If using the Foot Pedal you
want to block the table top trigger. To do this
rotate the middle flange on the edge guide to
block the trigger by rotating clockwise. To
unblock the trigger rotate counter clockwise.
E.
CONFIRM PUNCH ALIGNMENT:
Punch 2
sheets of paper and then fold one of the sheets
in half to make sure left and right margins
match. If needed make slight adjustment to
your edge guide.
OPERATION
A.
TURN ON/OFF:
Power switch is located on the
right side of the machine and has three
positions. Place it in the desired position
Table Top Trigger - ‘
I
’
Off – ‘
O
’
Foot Pedal Trigger – ‘
II
’
Allow for motor to get to full power by waiting
5 seconds before punching. Punching paper
too early could cause the machine to jam.
B.
PAPER INSERTION:
It is best to slide your
paper in forward and then slide to the left to
press up against the Edge Guide.
C.
PAPER PUNCHING:
The Table Top trigger will
cycle once you make contact with the Edge
Guide. Foot Pedal operation will trigger once
you have paper aligned and step on the Foot
Pedal.
