GBC Magnapunch 2.0, Installation & Operation Manual

Page: 23 / 120

Page 6-3
Magnapunch 2.0
– Installation and Operating Instructions
o
peRation
After the Magnapunch 2.0 has been turned on, the
Home screen displays. It is the menu from which you
set up and operate the Magnapunch 2.0. To return to
this menu from any other screen, press
HOME .
h
oMe
s
CReen
The Home screen displays the current status and
operational settings of the Magnapunch 2.0.
Use • UP and DOWN to scroll to each item on
the menu.
Press
• SELECT to select the item or command
the Magnapunch 2.0 to do something.
Home Screen with Edge Sensor and Foot Pedal Figure 14.
On.
Edge Sensor
The Edge Sensor virtually eliminates mis-punches by
preventing the punch to cycle when the media is not
fully inserted in the Punch Throat.
The Edge Sensor is On when the checkmarks
are highlighted in green and Off when the O is
highlighted in blue.
To turn On the Edge Sensor:
Use 1. UP and DOWN to scroll to EDGE SENSOR .
Press 2.
SELECT
to toggle between the settings.
Edge Sensor Screen
When the Edge Sensor is turned On, the
Magnapunch 2.0 detects when the media is properly
inserted in the Punch Throat. Green bars are
displayed on the User Interface to represent that
both the left and right edge of the media are fully
insert. When both bars are displayed, activate the
punch.
Edge Sensor Screen Indicating Correct Figure 15.
Alignment.
If the punch is triggered when only the left or right
bar is displayed, the punch will not trigger and an
ALERT EDGE SENSOR Error displays. When this
occurs, allow the Magnapunch 2.0 1-2 seconds to
clear and continue punching.
Note : When punching documents less than 6.5 (16.5
cm)inches, the turn OFF the Edge Sensor.
Punch
The punch is activated by the Tabletop Trigger or the
Foot Pedal. The selected mode appears green.
On the Home screen use the up and down keys until
the
PUNCH
mode is selected. The mode selected
is represented by the white arrow on the left. With
Tabeltop Trigger
or
Foot Pedal
selected, press
SELECT
to toggle between the two options.
Job Cycles
Job Cycles displays the number of punch cycles
for individual jobs. You can reset the counter on the
Reset Count screen. To exit the Job Cycles screen
without resetting the count, select
EXIT and then
press SELECT .