![background image](http://html1.mh-extra.com/html/gbc/h435/h435_instruction-manual_570987003.webp)
™
Reverse
On/Off
Heat
Cold
Note:
The H435 Jam Free Series Laminator has a limited warranty against pouch jams subject to normal use and when using GBC HeatSeal
®
pouches.
4
5
%LECTRICAL SHOCK HAZARD
$O NOT OPEN .O USER
SERVICABLE PARTS INSIDE
2EFER SERVICING TO QUALIFIED
SERVICE PERSONNEL
WARNING
™
Reverse
On/Off
Heat
Cold
Helpful lamination hints
Temperature setting Guidelines:
When laminating thin paper with light ink coverage, set the
temperature dial at the low end of the range. Thick paper and heavy
ink coverage require higher settings. Temperature settings will vary
due to the finish, chemistry and heat absorption properties of the
material being laminated.
Before laminating important or unique documents always run a test
pouch through the laminator using a similar type document.
As soon as the lamination is completed, remove from the rear of the
machine and place on a cool flat surface for cooling to prevent the pouch
from curling.
Your Laminator is equipped with an
automatic shut-off
function.
If the machine remains idle for one hour, the heater function will
automatically shut down. To reset the machine for operation, push
the power button off first and back on again.
Operation, hot lamination
Connect power cord to appropriate power source.
Push the power button
to turn the power “ON”
(fig. 2)
.
The power light will glow red.
Using the lamination guideline table below, select the appropriate
temperature setting for the pouch gauge thickness and material you
are laminating.
• If the laminated item appears to be cloudy, it means that the
laminator temperature is not hot enough. Allow the laminator to heat
for a few more minutes then run the pouch through again.
• If the laminated item is wavy, the TEMPERATURE is too hot. Verify
temperature selector is set at the appropriate temperature.
• Always allow sufficient time for the laminator to adjust to changes in
temperature setting.
Your machine has come equipped with a “minutes to ready” countdown
display. This display will show the estimated time when the machine will be
ready to laminate after you turn it on. Once the display reads “0,” the ready
light will turn green, and you will hear an audible alert. Please note that ready
time may increase or decrease depending on ambient room temperature.
Position the document to be laminated into a GBC laminating pouch,
so that the document is aligned to the folded sealed edge and the right
and left borders are equal
(fig. 3)
.
Insert the pouch straight into the machine,
leading with the folded
edge
(fig. 4)
. Do NOT use a carrier.
The pouch will automatically exit the rear of the machine. After the
pouch has stopped moving, immediately place it on a flat surface to
cool for one minute before handling
(fig. 5)
.
Your machine has come with a cleaning card that is to be used after
each laminating session prior to shutting off the machine. Adhesive
may exit the pouch and stick to the rollers while laminating, and the
cleaning card will remove this residue, keeping your machine in proper
working order and extending its life. Once you have run the card
through the machine and finished laminating, turn the machine off.
#OPY 0APER 3ETTING
'LOSSY 0APER 3ETTING
0HOTO 0APER 3ETTING
MIL
MIL
MIL
Operation, cold lamination
Connect power cord to appropriate power source.
Rotate the temperature dial to the “cold” position (fig. 2).
Push the power button to turn the power “ON” (fig. 2).
The ready light will glow green.
Use and laminate your GBC cold pouch.
(Pressure sensitive—non-thermal laminating pouch)
This machine is equipped with GBC Jam Free technology which will prevent
laminating pouches from jamming when used in accordance with this operation
manual and when using GBC branded pouches.
This machine is equipped with a pouch reverse feature, should you experience
a pouch jam due to an inferior pouch, improper loading and feeding of this
machine. Press the reverse button immediately if a pouch is jamming, and
gently pull the pouch to remove it from the front of the machine. Do NOT
reuse the samepouch. Load a new pouch and review the operation section
of this manual to assure proper operation.
Limited one-year warranty
ACCO Brands
®
(“ACCO”) warrants to the original purchaser for a period of one year after purchase that this ACCO product is free from defects in workmanship and material under normal
use and service. ACCO’s obligation under this warranty is limited to replacement or repair, at ACCO’s option, of any warranted part found defective by ACCO without charge for material
or labor. Any replacement, at ACCO’s option, may be the same product or a substantially similar product that may contain remanufactured or refurbished parts. This warranty shall be void
if the product has been misused, damaged by negligence or accident, or altered by anyone other than ACCO or ACCO’s authorized agents.
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. REPRESENTATIONS OR PROMISES INCONSISTENT WITH, OR IN ADDITION TO, THIS WARRANTY ARE UNAUTHORIZED
AND SHALL NOT BE BINDING UPON GBC. IN NO EVENT SHALL GBC BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, WHETHER OR NOT FORESEEABLE. ANY
IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES OR IMPLIED WARRANTIES, SO THE ABOVE EXCLUSION OR LIMITATION MAY NOT APPLY TO YOU.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. European Union Residents Only: This warranty does not affect the legal rights
which consumers have under applicable national legislation governing the sale of consumer goods
Register this product online at:
www.gbc.com
.
3PECIFICATIONS
'"#(EAT3EAL(
'"#(EAT3EAL(
%LECTRICAL
6(Z!7
6(Z!7
-ACHINE$IMENSIONS
vXvXv
XX--
-ACHINE7EIGHT
,"3
+'
-AXIMUM0OUCH4HICKNESS
-),
-),
-AXIMUM0OUCH7IDTH
v
CM
-AXIMUM4HRU0UT4HICKNESS
v
--
7ARM5P4IME
n-INUTES
n-INUTES
Important Safeguards
WARNING: FOR YOUR PROTECTION DO NOT CONNECT
THE POUCH LAMINATOR TO ELECTRICAL POWER UNTIL
YOU READ THESE INSTRUCTIONS COMPLETELY. KEEP
THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR
FUTURE REFERENCE. TO GUARD AGAINST INJURY, THE
FOLLOWING BASIC SAFETY PRECAUTIONS MUST BE
OBSERVED IN THE SET-UP AND USE OF THIS PRODUCT.
General safeguards
• Use the unit only for its intended purposes of laminating documents.
• Do not place anything in the pouch entrance of the laminator other
than documents in pouches.
• Place unit on a secure, stable work area to prevent the unit from
falling and possibly causing personal injury and damage to the unit.
• Follow all warnings and instructions marked on the unit.
• The socket outlet shall be installed near the equipment and shall be
easily accessible.
• Do not block the vent slots, this will cause the laminator to overheat.
Electrical safeguards
• The unit must be connected to a supply voltage corresponding to the
electrical rating shown on the unit.
• Unplug the unit before moving it, or when it is not in use for an extended
period of time.
• Do not operate with a damaged supply cord or plug. Do not alter the
attachment plug. The plug is configured for the appropriate electrical supply.
• Do not overload electrical outlets beyond their capacity; fire or electrical
shock could result.
• The unit is intended for indoor use only.
• Never push objects through the cabinet slots. Do not spill liquid of any
kind on this product.
• Close supervision is required when this product is used near children.
Service
• Do not attempt to service or repair the pouch laminator yourself.
Unplug the unit and contact an authorized GBC service representative
for any required repairs.
Safety instructions
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS
IMPORTANT TO GBC. IN THIS INSTRUCTION MANUAL AND ON THE
PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE
MESSAGES CAREFULLY.
THE FOLLOWING WARNING IS FOUND ON THE PRODUCT IN SEVERAL
LANGUAGES.
This safety message means that you could be seriously hurt or killed if
you open the product and expose yourself to hazardous voltage.
The following ISO and IEC symbols appear on this product, and their
meaning is as follows:
Special notice
Thank you for your recent purchase of a GBC Pouch Laminator. Your new
laminator may emit a slight odor during the initial stage of operation. It is
normal and will diminish after several hours of operation. Do not attempt
to do single sided lamination. This will destroy the laminator
Cleaning
Caution:
Unplug this product before cleaning.
• Wipe exterior only with a damp cloth.
Do not use detergents or solvents.
Jam Free feature: Important Information
HeatSeal
®
H435
HeatSeal
®
H435
1
2
3
4
5
6
7
8
1
2
3
4
5
1
2
1
2
3
4