![background image](http://html1.mh-extra.com/html/gbc/54c/54c_installation-and-operation-manual_3873898033.webp)
Page 6-9
SPIRE II Series
– Installation and Operating Instructions
t
Ips
• This process can be performed at any speed.
• Leave small gaps between each substrate as
you feed them into the laminator to make it
easier to separate them.
• The job is easier with two people; one to feed
the substrates and one to separate them as
they exit the laminator.
• AlWAyS RElEASE All TENSION BRAkES,
BOTH UPPER UNWIND AND REWIND,
BEFORE lOADING THE FIlM. ONCE
lOADED, START By ADDING TENSION TO
THE REWIND FIRST.
p
ressure
s
ensItIve
d
ecallInG
Use this process to apply a laminate and a
pressure-sensitive adhesive (PSA) to a graphic at
the same time. This is commonly referred as a decal
and it makes a sticker out of the graphic. After this
process is completed, the graphic can be mounted
to whatever substrate based on the application and
the type of mount adhesive used.
Examples include POP and window signage,
countertop graphics, and refrigeration unit signage.
MR
MR
U
U
R
Figure 43. PSA decalling diagram.
To decal a graphic:
1. Load a roll of PSA laminate on the top Unwind
roller.
2. Load a roll of PSA mount on the bottom Unwind
roller.
3. Refer to “Webbing the Machine” for step-by-step
instructions.
t
Ips
• When taping film liner to the Rewind Tube, use
only one piece of tape to allow the film to shift
if necessary and it is easier to remove the liner
later.
• When webbing the top laminate, make sure
the edges of the laminate line up from the
unwind to the laminate roller to ensure the
materials feed straight.
Summary of Contents for 54C
Page 4: ...SPIRE II Series Installation and Operating Instructions Page iii...
Page 10: ...SPIRE II Series Installation and Operating Instructions Page 2 2...
Page 38: ...SPIRE II Series Installation and Operating Instructions Page 6 14...
Page 43: ...Page 7 5 SPIRE II Series Installation and Operating Instructions Notes Date Note...