GBC 54C, Installation & Operation Manual

Page: 27 / 44

Page 6-3
SPIRE II Series
– Installation and Operating Instructions
4. Slide the roll of film onto the film shaft, ensuring
the adhesive does not make contact with the
roller.
5. Insert the film shaft back into the film shaft
Support Saddle.
6. Push the clevis pin through the holes in the
Support Saddle.
Figure 30. Shaft Clevis Pin in the Support Saddle.
7. Center each supply roll on the shafts using the
rulers on the shafts.
W
eBBInG the
m
achIne
Prior to webbing the machine, ensure the supply
rolls are centered on the shafts. Also make sure to
remove all brake tension on the unwind and supply
shafts before you begin.
Caution: Press STOP to ensure the machine is not
running.
Note: The photos in this section are of a different
model SPIRE laminator. However, webbing the
machine is the same.
To web the machine:
1. Guide the top film under the Idler and back up to
the rewind tube.
Figure 31. Pulling pressure sensitive adhesive (PSA) film to
the Rewind Tube.
2. Fasten the center of the film to the to the rewind
tube with tape.
Figure 32. Taping film to the rewind tube.
3. Make two full wraps around the rewind tube.
4. Using a very sharp utility knife, lightly score the
laminating film without cutting the release liner.