![background image](http://html1.mh-extra.com/html/gbc/17p/17p_installation-and-operation-manual_571055014.webp)
ProCut 17P – Installation and Operating Instructions
Page 5-2
WARNING
: Keep hands and fingers away from
the Clamp and Cutting Blade. Failure to observe
this warning could result in severe personal
injury.
c
ontrol
P
anel
In addition to the manual cut settings, the ProCut 17P
can be programmed for in front and behind the blade
cutting. Up to 80 programs, containing 99 steps each,
can be stored for reuse.
The Control Panel includes an LCD display and keypad.
The LCD shows the current and programmed settings of
the cutter and the keypad is used to set up and program
the cutting programs.
a. lcd d
IsPlay
The display shows the current settings of the machine.
The values shown can be displayed in millimeters or
inches.
5
inch 0095 00
17.00
01 00.00
02 00.00
03 00.00
04 00.00
05 00.00
06 00.00
07 00.00
08 00.00
Figure 9. Rendering of LCD Display
c
laMPInG
F
orce
:
Indicates the amount of pressure applied to the media.
The pressure can be set from 1 (highest) to 9 (lowest)
with the default being 5. You must be in the Clamping
Force setting screen to adjust the pressure.
s
aFety
c
urtaIn
a
larM
:
Indicates whether the alarm buzzer is enabled or disabled.
r
eBladInG
M
ode
:
Used when changing the blade.
WARNING:
Blade removal should only be done
by a GBC Technician. Failure to observe this
warning could result in severe personal injury.
B
ehInd
the
B
lade
:
Cut value is measured from behind the blade to the Back
Gauge.
I
n
F
ront
oF
the
B
lade
:
Cut values are measured by the amount of media
the Back Gauge pushes in front of the blade from the
previous cut.
B
ack
G
auGe
v
alue
:
The numeric value displayed is the current position of the
Back Gauge.
P
roGraMMInG
v
alues
:
Displays the programmed cuts entered for each step.
c
ount
v
alue
:
Provides the total cuts performed during the lifetime of
the machine.
B. k
eyPad
The keypad is used to:
•
Set the cutting size when operating in manual
mode
• Change cutter settings
• Select or create programs
Figure 10. Keypad
Use the numeric keypad to enter the cut values in
manual mode or when entering programs. To add a
decimal, press the decimal button.
u
P
and
d
oWn
a
rroW
B
uttons
:
At the home screen, the Up and Down arrow buttons
can be used to move the Back Gauge. Pressing a button
once will make minor adjustments. Holding the button will
allow the Back Gauge to move more quickly for larger
adjustments.