BGB7200
Page 5
Make sure the wire is hanging out before
proceeding to the next step. If it has fallen
inside the tube, use a bent wire to “fish” it out.
Hardware & Tool Required
Bolt
#13 Screw (M8x50 mm)
[4 Pieces]
Washer
#59 Washer (M8, OD16)
[4 Pieces]
#32 Washer (M8, OD16)
[3 Pieces]
Front & Rear Stabilizer Assembly
With the help of an assistant, attach the
Front Stabilizer
(#02)
to bracket at the front of
Main Frame (#01)
. Insert two
Screws (#13)
through two
Washers (#59)
followed by the
Main Frame (#01)
and
Front Stabilizer (#02).
Secure them
together by tightening two
Screws (#13).
Now attach the
Rear Stabilizer (#03)
to the bracket at rear
of
Main Frame (#01)
. Insert two
Screws (#13)
through two
NOTE
: The
Front Stabilizer (#02)
has wheels built in
for ease of relocating and transporting the unit.
The
Rear Stabilizer (#03)
does not have wheels. Both the
Front Stabilizer (#02)
and
Rear Stabilizer (#03)
have
Foot
Pads (#14)
for extra stability. Please place an exercise mat
underneath the unit to avoid scratches or marks on the surface
that it rests on.
Washers (#59)
followed by the
Main Frame (#01)
and
Rear Stabilizer (#03).
Secure them together by tightening
two
Screws (#13).
Nut
Tool
#33 Nut (M8)
[3 Pieces]
#64 Tool (S6)
#65 Tool (S13/14/15)
Seat Assembly
Remove the three
Washers (#32)
and three
Nuts (#33)
that are pre-installed on the
Seat (#09)
as illustrated and
set them aside. Align the holes of the
Seat (#09)
to the
Horizontal Seat Bar (#08)
as shown in the diagram.
Next, secure them together using three
Washers (#32)
and three
Nuts (#33)
that were previously removed.
A s s e m b l y S t e p 2
A s s e m b l y S t e p 1
Assembly Instructions
