Page 9
A s s e m b l y S t e p 7
Feed the
Left Handle Pulse Wire (#47)
and the
Right Handle Pulse Wire (#48)
through the side hole in
the neck of the
Center Post (#04)
and through the front hole of the
Center Post (#04)
as directed by the
arrow in diagram No. 1. You will need to connect these wires to the
Monitor (#43)
in later assembly step.
FRONT VIEW
BACK VIEW
Please also ensure that
Handle Sensor Wire [Lower] (#46)
and
Main Sensor Wire [Middle] (#45)
are fed
through the same hole as shown in diagram No. 2. Please refer to diagram No. 3 and No. 4 to confirm
proper assembly.
The
Round End Cap (#42)
is
pre-installed to hold the
Left & Right Handle Pulse Wires (#47 & #48)
as
seen in diagram No. 2. However, you may remove the
Round End Cap (#42)
so you can tuck in the wires
more if there is too much give, or you do not want the wire to hang out so much. If you remove the
Round
End Cap (#42)
, please remember to snap it back in place to hold all the wires in place.
Assembly Instructions
BGB 300