
9
EN
Nominal Diameter
of Wood Screw (mm)
Recommended Size
of Center Hole (mm)
3.1
2.0-2.2
3.5
2.2-2.5
3.8
2.5-2.8
4.5
2.9-3.2
4.8
3.1-3.4
5.1
3.3-3.6
5.5
3.7-3.9
5.8
4.0-4.2
6.1
4.2-4.4
●
Removing Bolt
To remove the bolt, hammer the point of the driver bit
at the bolt head and force the tool properly. Switch on
the tool slowly and then speed it up gradually. Once
the bolt is taken out, release the switch trigger. (Fig M)
CAUTION:
Please put the gear in “1” (low speed): Make sure
the head is inserted vertically into the screw head,
otherwise the screw or the head may be damaged.
Please select the appropriate torque according to
your word needs.
1.Drive Bit
2.Bolt
Fig.M
2
1
● Hook Installation
CAUTION:
When installing the hook,be sure to fix it with screws.
Otherwise,the
hook may be detached from the tool,causing life
harm.
Hooks facilitate temporary suspension of tools and
can be mounted on either side of the tool. To install
the hook. Insert it into a groove on the first side of the
tool housing and secure it with screws. To unscrew
the hook, loose the screw and take it out.(Fig. N)
1.Screw
2.Hook
3.Groove
Fig.N
1 2
3
MAINTENANCE AND INSPECTION
● Inspecting
When the tool is distributed or withdrew, the custodial
staff must give it a daily inspection; before use, users
must give it a daily inspection; the companies using
the tool must have professionals to inspect the tool
regularly; Inspection cycle should be shortened in the
area of humid climate and changeable temperature
or under poor using conditions; Inspect in time before
rainy season.
The tool that is inspected to be qualified should
be marked with a sticker on which there are words
“identifier, name or identification of the inspecting
company, name or identification of the inspector and
effective date.
The tool must be maintained by maintenance
companies recognized by original manufacturer.
The end-users and maintenance departments are
not allowed to change original parameter of the tool,
or adopt alternate materials whose performance is
lower than original ones or spare parts that don not
correspond to the specifications.
● Cleaning Ventilation Slots
For safe and proper working, always keep the power
tool and its ventilation slots clean. Use a soft, clean
and dry brush to clean the ventilation slots regularly
or when they’re clogged.
● Inspecting the Mounting Screws
Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so could result in serious hazard.
● Cleaning
Only use soft and dry cloth to wipe the body of the
tool. Do not clean the tool with wet cloth, thinner,
gasoline or other volatile solvents.
* To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by authorized service centers, always
using original replacement parts.
For battery tools:
Ambient temperature range during operation and
storage: 0°C
- 45°C
.
Recommended ambient temperature range during
charging: 5°C
- 40°C
.
The battery packs of our company are constantly
updated, please look forward to our service and latest
news!
Charger
Battery Pack
Model
GC1000
GC1020
GC1040
Summary of Contents for GC2020
Page 2: ...Read through carefully and understand these instructions before use EN...
Page 11: ...11 EN...
Page 12: ......