Gazelle GC2020, User Manual, Page: 6 / 12

6
EN
Installing the Battery
NOTE:
The battery is supplied partially charged. To ensure full
capacity of the battery, completely charge the battery
in the battery charger before using the tool for the first
time.
To install the battery firmly, insert it properly all the
way until it locks in place with a little click. If not, it
may accidentally fall out of the tool, causing injury to
you or someone around you. Avoid overexerting or
hammering the battery into the motor housing with the
help of other objects. (Fig. A)
1.Battery
Pack Button
2.Battery Pack
Fig.A
1
2
● Removing the Battery
To remove the battery, press the unlocking buttons
on both sides of the battery and pull out the battery
downwards. (Fig. B)
Fig.B
2
1
1.Press The
Battery Pack
Button In
The Arrow
Direction
2.Remove The
Battery Pack
● Battery Indicator
The four charging lights may flash in red color if the
tool is overheated or overloaded. As temperature
recovers or over-load protection is removed, press the
switch and the tool can be started normally.
Current power of the battery will be indicated by the
battery indicator when pressing the battery button or
switching on the tool. (Fig. C) Four red LED lights are
set to indicate the battery power which can be referred
to the following table.
Fig.C
1
1.Battery Indicator
Light
Status of Red LED
Lights
Approx. Battery Power
Left
4 lights lit 75%-100%
3 lights lit 50%-75%
2 lights lit 25%-50%
1 light lit 10%-25%
1 light extinguished Low level
● Continuous Use
If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for
15minutes before proceeding with a fresh battery.
● Over Discharge Protection
This machine is equipped with an over discharge
protection circuit. When the battery is low, the
protection circuit will be opened and the machine will
stop rotating.
● Disposing of Battery Cartridge
Lithium ion battery is contained in the battery cartridge.
For environmental protection, recycle or dispose of
the worn out battery properly. Please consult with your
local relevant departments about how to recycle and/
or dispose of the worn out battery.
GENERAL DESCRIPTIONS
1
2
3
4
5
6
7
8
1.Speed Selector button
2.Torque Presetting
Ring
3.Drill Chuck
4.Switch Trigger
5.LED Light
6.Battery Pack
7.Battery Indicator Light
8.Reversing Switch Lever
● Installing or Removing Tool
The tool here includes driver bit, drill bit, etc, which
differs from the concept of power tools or machines.
CAUTION:
Before operation, always set the reversing switch lever
in the central position and remove the battery. Mustn’t