52
MAKE-UP AIR
1. Kitchen make-up air supply is turned on______Yes______No
2. Type of make-up air
¨
Ceiling Registers
¨
Built into Hood
¨
Ceiling Linear Diffusers
¨
Other
3. If ceiling register or linear diffusers approximate distance from face of hood
_____________________________________________________________
AIR VOLUME READINGS
Push “Start Fan” and take velocities. Record as follows: Exhaust record in the “EX” row, Exhaust at Custom
Air baffles (if applicable) record in the “CA” row, and Make-up Air record in the “MA” row.
WASH MODE TEST:
1. Model of Control Cabinet _______________________________________________
2. Push “START WASH” on Control Cabinet. Check the following:
A. Exhaust fan off_____Yes_____No
F.
Detergent pump operating ____Yes ___ No
B. Damper closes to the front of the hood after
G. Length of wash cycle ________Minutes
approx. 70 sec.____Yes ____No
H. Water pressure_________________PSI
C. Water turned on_____Yes_____No
I.
Water temperature_____________°F
D. All nozzles spraying_____Yes_____No
J. Any ventilator leaks_____Yes_____No
E. Green light is on and “Wash On” is displayed on
K. Drains free and clear_____Yes_____No
C-6000 command center____Yes ____No
L. Brand of detergent used______________
3. At the conclusion of check A through L above, push the “EXIT” button on the C-6000 command center.
Check the following: A. Did the water shut off ___Yes ___No B. Did the damper stay closed ___Yes ___No
4. Push “START FAN”. Check the following:
A. Green light comes on and “Fan On” is displayed on C-6000 command center___Yes ___No
B. Damper fully opens after approx. 45 seconds ___Yes ___No
.
O
N
M
E
T
I
.
O
N
L
A
I
R
E
S
D
O
O
H
T
H
G
I
R
O
T
T
F
E
L
M
O
R
F
)
M
P
F
(
S
E
I
T
I
C
O
L
E
V
R
I
A
R
I
A
P
U
-
E
K
A
M
R
O
K
N
A
B
R
E
T
L
I
F
,
T
O
L
S
D
O
O
H
E
G
R
A
H
C
S
I
D
E
G
A
R
E
V
A
X
E
A
C
A
M
X
E
A
C
A
M
X
E
A
C
A
M
VENTILATOR START-UP INSPECTION REPORT
For Model “CG3” Series Ventilators with C-6000 Series Control
Job Name ______________________________________________________________________________
Gaylord Representative ____________________________________________________________
Address ________________________________________________________________________________
Representative Company Name ______________________________________________________
______________________________________________________________________________________
File Number _______________________________________________ Date _________________
City/State Zip
Facility Contact Name _________________________________________ Phone # ____________________
CSA Contacted __________________________________________________________________
FIRE MODE TEST:
CAUTION: Before any fire tests are performed, check with building superintendent to see if Gaylord control
cabinet is tied into building alarm, monitoring system and/or Fire Department.
THERMOSTAT TEST (For CG3, CG3-FDL, and CG3-FDT)
With the exhaust fan on, open electrical compartment on Control Cabinet and push and hold for 20 seconds
the “Fire Test Switch”. The following should occur:
1. Damper closed to rear_____Yes_____No
3. Exhaust fan shut off_____Yes_____No
(N/A on CG3-FDL and CG3-FDT)
4. Steady red light on and “Fire In Hood” displayed .
2. Water turned on_____Yes_____No
on C-6000 Command Center ____Yes ___No
NOTE: Water will continue to run for 5 minutes after the “Fire Test Switch” button is released. The water may be
shut off prior to the end of the cool down cycle by pushing the “EXIT” button on the C-6000 command center.
Upon completion of the thermostat test push the “EXIT” button on the C-6000 command center. The following
should occur:
A. Water shut off ___Yes ___No
C. Steady red light turned off and “Fan Off”
B. Damper closes to front ___Yes ___No
displayed on C-6000 Command Center___Yes ___No
(N/A on CG3-FDL and CG3-FDT)
REMOTE FIRE SWITCH TEST (Optional Equipment):______Equipped______Not Equipped
Open fire switch and flip toggle switch to the “ALARM” or “TEST” position. The following should occur:
1. Water spray turned on_____Yes_____No
4. Flashing red light on and “Ext. Fire Active”
2. Damper remained open (or opens) ____Yes____No
displayed on C-6000 Command Center
3. Exhaust fan remained on (or turned on)____Yes____No
_____Yes_____No
INSTALLATION INCLUDES THE FOLLOWING:
¨
Gaylord Heat Reclaim Unit (HRU)
¨
The Gaylord “Quencher” Fire Protection System
¨
Gaylord Clearair Pollution Control Unit (RSPC)
¨
Gaylord Rooftop Unit (GRT)
¨
Gaylord Distributor (UDS)
¨
Wet Chemical Fire Protection System
¨
Gaylord Recirculating Wash System (GRW)
Personnel provided with ventilator technical manual________Yes________No
Inspection Witnessed By (Print Name) ______________________________________________________
Signature ________________________________________________
Date _______________________
Comments ____________________________________________________________________________
____________________________________________________________________________________
____________________________________________________________________________________
__________________________________________________________________________________________________
__________________________________________________________________________________________________
Distribution: WHITE-Gaylord Industries, Inc. YELLOW-Customer PINK-Dealer GOLDENROD-Sales Rep Litho U.S.A.
GAYLORD INDUSTRIES, 10900 S.W. Avery Street • Tualatin, OR 97062-1149
PHONE:1-800-547-9696 • FAX: 1-503-692-6048 •
email:[email protected]
Form No. CG36000SUR
Summary of Contents for C-6000 Series
