5
Pro
line
Pro
line
7
Installation
6
Warning!
Mounting and installing of the fixture may
only be executed by certified service personnel,
in accordance with the applicable local laws and
regulations.
6
Warning!
The fitter is responsible for correct and
safe installation.
6
Warning!
Ensure the local cabling can support the
voltage and current requirements of the luminaire.
6
Warning!
Avoid coiled cords and keep mains
leads separated. This prevents electromagnetic
interference.
6
Warning!
Do not connect or disconnect the Wieland
RST20i3 plug under load.
1000W
1 m -
40 in
3
B1
B2
4
B2
B3
B1
5
7.1
Preparing the luminaire for use
1. Switch off mains power.
2. Read the Gavita light distribution plan.
3. If not pre-installed, install the lamp in the fixture (see paragraph 10.2).
4. If not pre-installed, screw the mounting point into the luminaire (5).
7.2
Installing the luminaire.
1. Mount the suspension bracket* according to the light distribution plan.
2. Hang the fixture by its two mounting points onto the suspension bracket (4). The two mounting points are spaced 30 -
32 cm apart.
1
Caution!
Always hang the fixture horizontally. If necessary adjustments can be made by screwing the mounting point
in or out.
To install other fixtures, repeat the steps from paragraph 7.1 and 7.2.
* The suspension bracket is delivery dependent, it may differ from the image.
7.3
Repeater bus connection kit (optional)
The repeater bus connection kit contains the following items:
A 2 x EMC ferrite snap-on black bag (13x12x5x25.5x2.4)
B 4 x Gavita splitter 1 to 2 6P6C grey RJ25 (in bag)
C 8 x grey modular jack interconnect cable 6P6C RJ25 (in bag)
D 8 x SNAP-ON ferrite core grey (in bag)
E Interconnect cable 6p 25 meter grey (in bag)
