20 / 28
16540_jh_V1
Necessary pre-settings on the transmitter
In the transmitter it must be selected a free model memory, the
model type must be “surface model“ and the channel 1 direction
must be set so that in “motor off“ position the power indicator
must show -100%.
The flight mode must be set on channel 5. Then program a 2
way switch for channel 5 to control the flight mode:
Attitude mode:
Channel 5 = -100% to +50%. The stick move-
ment influences the
HoTT Hornet
reaction on Roll and Nick. It
allows a maximal angle of about 50° at 100% of stick move-
ment. Mode suggested for beginners. The stick movements
acts directly proportionally to Roll and Nick.
Rate mode:
Channel 5 = more than +50%. The stick movement
influences the rate without angle limit. Aerobatic mode that
allows rolls and loopings.
We suggest to set the fail-safe on channel 5 and channel 1 at
-100% , so that in fail safe it is active the attitude mode.
Program always the motors stop switch on the transmitter. (See
transmitter manual) This prevents accidental starting of motors,
thus reducing the risk of injury.
Initialization of the gyro in the receiver
Once the
HoTT Hornet
has been switched on, the gyro immedi-
ately becomes active but still needs to be initialized. To initialize
the gyro, keep your
HoTT Hornet
still when you switch it on. The
calibration process can only be performed when the receiver is
absolutely still. After 3 seconds in still position you will hear
beeps emitted by all motors.
These "wiggles" signal that initialization has been successful and
that calibration is complete. Always wait until the calibration pro-
cess has finished before starting to fly the model.
The motors will not start until the calibration is successfully
completed.
Auto-flip function version 16540.CAM
The auto-flip function allows you to flip your copter in a very easy
way. It is essential that you control in Attitude mode (function not
allowed in Rate mode). The auto-flip function is controlled by a
switch assigned to channel 6. (see manual S1019) Activate the
switch and within 5 sec move the nick or roll stick to more than
50% of its course, then the copter makes autonomously a flip in
the selected direction. After the flip it is possible to have some
little position movements (<10°)
Do not forget to set the failsafe up!
Program the motor stop switch!
Safety function - motors-off
