18
GAUI
TAI SHIH HOBBY CORPORATION
Motor installation
馬達組裝
GAUI
TAI SHIH HOBBY CORPORATION
Motor installation
馬達組裝
M3x3........................x2
M3x6........................x6
M3x10......................x2
M3x10
M3x3
M3x6
M3x3
M3x6
M3x10
M3x6
0.1mm
1.將上方組裝好的馬達總成試組裝至機身，
以調整間隙約1mm後在將M3x6、M3x10螺絲鎖緊。
2.確認間隙無誤後可鎖緊馬達板固定螺絲。
1. Use M3x6 screws to assemble Motor mount to
the bridge first.
2. Assemble the motor on Motor mount with M3x6
M3x10 screws (DO NOT TIGHTEN these
screws all the way YET), install the pinion onto
motor shaft making sure about fitting then tigten
with M3x3 screws.
1.使用M3x6螺絲組裝馬達板與主軸銜接座。
2.將馬達組裝至馬達板上並含上M3x6、M3x10
螺絲不鎖緊，套入馬達齒並注意馬達齒與軸心
切齊後鎖緊M3x3螺絲。
1. Trial install the above Motor/motor mount /
bridge assembly onto the main frame.
This is for adjusting the mesh between pinion &
main gear to about 1mm.
When the mesh is adjusted, tighten the M3x6 &
M3x10 screws on the motor mount.
2. After confirming the gear mesh fitting.
Tighten the motor mount onto frame with the
frame screws.
21
螺絲均需上止滑劑
All screws on side plates should
be applied with thread lock.
