FUNCTION AND OPERATION EXPLANATION
23
www.gateway.com
DOWNMIX mode
Stereo and 5.1 CH output have been set in the
DOWNMIX mode of this unit.
When this system is set in stereo output mode:
appears on the display screen.
This means when operating this unit, only L, R, LFE,
SUB and LINE OUT has output.
REAR PANEL
When this system is set in 5.1 CH output mode:
appears on the display screen.
This means each channel has output. (only when playing
DVDs disc recorded with multi-audio, when the above
channels have output. Otherwise the output mode is the
same as in stereo mode). But the LINE OUT output on
rear panel has no output.
CENTER DELAY
CENTR DELAY in this unit is between 0~5MS. When
entering CENTR DELAY setting, by pressing the
key and SELECT/ENTER confirm key, you can select the
your desired center delay effect.
REAR DELAY
REAR DELAY in this unit is between 0~15MS. When
entering rear delay setting, by pressing the
key and
SELECT/ENTER confirm key, you can select the your
desired rear delay effect.
TEST TONE
There are two modes ON/OFF set in this unit.
When the setting is in ON mode, this system will test the
tone of the speakers connected automatically. This ON
mode must be changed to OFF mode after the testing
has been completed. After this unit is turned off, it will
automatically enters the OFF mode.
AUDIO SETUP
Press SETUP key on remote to enter “...SETUP
MENU...MAIN PAGE...”
By using the 4 Arrow keys(seesaw) and “ENTER” key,
you can select the function setup you want.
Preset the following items.
AUDIO OUT---To set the audio out according to your
audio output connection mode, for instance, if you want
the audio out from the SPEAKERS(2/rear panel) the
audio out must be set to ANALOG; if you want the audio
out from the COAXIAL OUT(5/rear panel), it must be set
to SPDIF/RAW or SPDIF/PCM.
SPDIF/RAW means that if the audio input signal from the
disc being played in this unit is 5.1CH or 2CH, then the
audio output is 5.1CH or 2CH; SPDIF/PCM means that no
matter the audio input signal from the disc being played in
this unit is 5.1CH or 2CH, the audio output is always 2CH.
AUDIO IN---if this unit has been connected to OPTICAL
IN/COAXIAL IN, and you are going to use these
connections, for example, when you want to use the satellite
receiver as the audio input source, then you must set the
AUDIO IN to OPTICAL IN, otherwise you cannot listen to the
audio from the satellite receiver, when you do not want to use
the AUDIO IN any more, you must set the AUDIO IN to OFF
mode, otherwise you cannot use this unit to play disc.
DUAL NONO---in this unit, there are the following four kinds
of analog output: stereo, L-mono, R-mono and Mix-mono.
DYNAMIC
-- -- FULL
-- --
-- --
-- --
-- --
After entering the DYNAMIC setup item, by pressing
key
and ENTER confirm key, the output level can be adjusted.
PRO LOGIC---Before playing a CD, VCD, or 2CH DVD,
make the following settings to get 4.1CH output: L, C, R,
SUB and S. Setting:
SPEAKER SETUP to 5.1CH, and PRO LOGIC to ON in
AUDIO SETUP item.
AUDIO OUT
ANALOG
SPDIF/RAW
SPDIF/PCM
AUDIO IN
DUAL MONO
DYNAMIC
PRO LOGIC
PRO LOGIC II MODE
LPCM OUTPUT
L
F
E
TITLE
1
CHAPT
1
MIN
01
SEC
48
L
F
E
Summary of Contents for LD-220
Page 2: ......