Gateway E-9525R, User Manual

Page: 19 / 130

Mounting your server into a cabinet www.gateway.com
13
Uninterruptible power supplies
Use an uninterruptible power supply (UPS) to protect your server from data loss
during a total power failure. A UPS uses a battery to keep your server running
temporarily during a power failure and lets you save your work and shut down
your server. You cannot run your server for an extended period of time while
using only the UPS. To buy a UPS, visit
accessories.gateway.com .
Mounting your server into a cabinet
Caution
Before attaching cabinet accessories,
make sure that the server is turned off
and all power cords are unplugged.
The fixed-rail cabinet mounting hardware included with your server should be
used with standard 4-post cabinets that have front and back vertical posts. If
your cabinet is a different type, obtain mounting hardware from the cabinet
manufacturer.
Caution
The cabinet must provide sufficient
airflow to the front of the server to
maintain correct cooling.
The fixed-rail rackmount kit contents:
■
Front server rails (2)
■
Back server rails (2)
■
Fastener pack (1)
■
Locking screws (4)
■
Mounting nuts (4)
■
Mounting screws (4)
If you ordered the optional tooless-rail kit for your server, refer to the
instructions included in the kit.
Important
The example shown is an E-9425R server,
but the setup instructions are the same
for this server.
To mount your server in a cabinet:
1
Align the slots in the front server rails with the studs on the side of the
server, then engage the slots with the studs and slide the rails forward until
they stop.
2
Align the locking screw holes in the rails with the threaded screw holes
in the server, then install one locking screw through the each front server
rail.
Stud Stud Locking screw (installed)
Front server rail
(installed)