NetXpress LX & CM-30R Installation & Operation Manual
4
–
Configuration & Operation
Version 1.1
4-56
GatesAir, Inc.
Intraplex Products
systems operating in E1 mode, you also need to enable CAS signaling for the internal TDM bus on
which the voice channel module resides. Otherwise, the signaling bits are not sent over the network.
The next two fields appear if you select the
Enable Voice Signaling
check box.
Voice Card Used:
Select the voice module to be used for signaling, and the system determines the
signaling insertion byte:
Enter signaling insertion byte manually
,
VF-15 or VF-16A
,
VF-16A in
VF-25 mode or VF-25
, or
VF-40
.
Signaling Insertion Byte:
If you selected to enter the insertion byte manually, type the byte
number. If you selected a voice module, this field is read-only.
Statistics Measurement Interval (sec):
Provides update interval (in 5 to 10 seconds) on the
stream statistics. The default is 5 seconds.
Cancel:
Click this button to return to the
Streams
Table
page without creating a new stream.
Prev:
Click this button to return to the
Stream
Creation
Stage
1
page.
Next:
After completing the
Stream
Creation
–
Stage
2
page, click this button to advance to the
Stream
Creation
–
Stage
3
page (Figure 4-50).
Note:
If you clicked
Multi-Unicast
for
Transmission
Type
on the
Stream
Creation
–
Stage
2
page, Stage 3 shows four tabs (Figure 4-51). You need to fill in the IP parameters on each tab
for that specific stream before clicking
Next
to advance to Stage 4 of the stream creation
process.
Stream Creation
Stage 3
Figure 4-50. Stream Creation
–
Stage 3
–
IP Parameters
