124756 / 6-2014
28
O P E R A T I O N & M A I N T E N A N C E
Coulter Gang Angle Adjustments (Cont’d)
Figure 43
The indicators are factory set, but if adjustment is
necessary, loosen the jam nut (item 1) and set screw
(item 2) to move the indicator rod.
Working Depth Adjustment
Figure 44
Figure 45
The working depth is set using the crank (item 1) above
the main section hitch.
Raise the implement fully and hold the control lever
(green hoses) for five seconds to rephase the wheel lift
cylinders. Drive forward at working speed and lower the
implement to approximate working depth. Stop and shut
off the tractor.
Turn the crank (item 1) until the stop (item 2) contacts the
depth stop valve (item 3). Start the tractor and raise the
implement. Drive forward and lower the implement until it
stops dropping. Stop and shut off the tractor and check
the working depth.
NOTE: It may take several tries to get the exact depth
desired, but once it is set it will return to that
depth everytime depending on field
conditions.
GM00006
1
2
GM00013
1
GM00052
1
2
Summary of Contents for Magnum Coulter Disk
