The XA35 Setup
Page 12
Closing the Housing
Carefully inspect
o-ring on back half and the sealing surface on front half. Make
sure they are clean and in good condition.
Pull up
the Power control.
Place back half onto the front housing half.
You will clearly see when the
housing halves align and seat together properly.
Locate and close
the two latches at the same time.
CAUTION
:
The safety latches must be closed and locked prior to use to avoid
opening underwater. It is your responsibility to make sure the latches are secure,
locked, and in good condition. DO NOT enter the water with a faulty latch. Gates
will replace a damaged or faulty latch free of charge.
Inspect the o-ring on the rear shell
and the sealing surface on the
front shell. They should be clean
and free of nicks, marks or
scratches.
Pull up the Power control.
Mate the shells and close the two
latches. The shells should mate
without obstruction.
2
1
