background image

SURFACE FIXED DIGITAL 

GATE LOCK

TO CHANGE THE CODE

1.  Check the original code is working on both keypads
2.  For standalone keypad: remove rear black plate from keypad using flat screwdriver or similar tool.

For DGLW double sided locks

 - to remove the keypad attached to the lock:

Left handed lock

 - Slide out the internal lock mechanism and the keypad can be removed by 

accessing the screws through the inside of the lockcase.

Right handed lock

 – Insert a flat screwdriver into the hole in the forend plate and lever out the 

keypad retaining plate (see image opposite). This will release the keypad.

3.  Turn the keypad over and remove the 4 red screws
4.  Lift off the covering panel. Be careful as there are 10 springs attached to this panel. Note that 

the red tumblers relate to the code shown above. Also note that the C tumbler is uncoloured and 
should not be removed.

5.  To change the code hold the keypad with the code buttons down and depress & hold the C 

button (if this is not done you may damage some of the internal components). Reposition the 
tumblers to the new code (red tumblers are coded and blue tumblers are uncoded). Ensure that 
the square cut-out on each tumbler is facing the outside of the lock body, also ensure that the 
coloured mark is facing upwards. If any one tumbler is upside down or the wrong way round the 
lock will not work and if forced will break the internal components. The code must always start 
with a ‘C’.

6.  Replace the covering panel and tighten the 4 red screws.
7.  The code is now changed, check to see that it is working correctly and make a note of the code 

for future reference. Once satisfied that the lock is working correctly refit keypads to the lock 
case.

SPECIFICATION 

SHEET 

MAINTENANCE

Every 3 months:

1.  Remove keypads from the lock
2.  Spray the inside of the lock thoroughly with WD40 or equivalent, through the 

tumbler holes at the back of the lock

3.  Spray all the fixing accessories and the latch with WD40 or equivalent.
4.  Push each of the buttons and rotate the knob several times to make sure the lock 

is working smoothly

LOCK CODE:

C

 

_

 

_

 

_

© Copyright Gatemaster 2022

+44 (0)1243 558 580

www.gatemasterlocks.com

VISIT GATEMASTERLOCKS.COM FOR MORE 

INFORMATION

DGLW

Reviews: