Set width of pedestrian mode: Move the first and the second switches of SW (DIP-switch) to
ON position (down), press button 4 to open the gate, see
Verify open direction
section.
Wait until the gate travels the distance that you desire (the distance range is 0.3m~2.5m or
wait for 3~10 sec.), it is regarded as ‘the width of pedestrian mode’. Then press the same
button to stop the gate, wait for some time (1~44sec.). Close the gate by pressing the same
button. Press the same button again to stop the gate or the gate will stop at its closed
position automatically if the limit switch is reached. Then move the first and the second
switches of SW (DIP-switch) to OFF position (up) immediately. Thus ‘the width of pedestrian
mode’ has been set. If you open the gate by pressing button 4, the gate will stop at the
expected position that you have set.
﹡
Set auto-close function of pedestrian mode: Move the first and the second switches of SW
(DIP-switch) to ON position (down), press button 4 to open the gate, see
Verify open
direction
section. Wait until the gate travels the distance that you desire (about 3~10 sec.)
Then press the same button to stop the gate, wait for the time you desire (1~44 sec.), this
period of time is known as ‘auto-close time of pedestrian mode’. Close the gate by pressing
the same button. Press the same button again to stop the gate or the gate will stop at its
closed position automatically if the limit switch is reached. Then remember to move the first
and the second switches of SW (DIP-switch) to OFF position (up) immediately. At this point,
‘the auto-close function of pedestrian mode’ has been set. (Note: the new width of pedestrian
mode has been re-programmed and replaces the original width that you have set in
Set
width of pedestrian mode
section.) If you open the gate by pressing button 4, the gate will
stop at the new expected position that you have set. After the time passes that you have set,
the gate will close automatically.
Cancel width / auto-close function of pedestrian mode
Cancel width and auto-close function of pedestrian mode (factory preset):
Move the first and
the second switches of SW (DIP-switch) to ON position (down), press button 4 to open the
gate, see
Verify open direction
section. Wait for more than 15 sec, then press the same
button to stop the gate, and wait until the gate closes automatically (45 sec). Stop the gate by
pressing button 4, or the gate will stop at its closed position automatically if the limit switch is
reached. Then move the first and the second switches of SW (DIP-switch) to OFF position
(up) immediately. Thus ‘the width and auto-close function of pedestrian mode’ has been
cancelled.
﹡
Cancel width of pedestrian mode, keep auto-close function of pedestrian mode: Move the
first and the second switches of SW (DIP-switch) to ON position (down), press button 4 to
open the gate, see
Verify open direction
section. Wait for more than 15 sec. then press the
same button to stop the gate, wait the number of seconds that you desire (1~44sec.), then
close the gate by pressing the same button. Press the same button again to stop the gate or
the gate will stop at its closed position automatically if the limit switch is reached. Then move
the first and the second switches of SW (DIP-switch) to OFF position (up) immediately. Thus
‘the width of pedestrian mode’ has been cancelled, ‘the auto-close function of pedestrian
mode’ has been reserved. (Note: the new auto-close time of pedestrian mode has been re-
programmed in the device and replaces the original auto-close time of pedestrian mode
which you have set in
Set auto-close function of pedestrian mode
section.)
﹡
Keep width of pedestrian mode, cancel auto-close function of pedestrian mode: Move the
first and the second switches of SW (DIP-switch) to ON position (down), press button 4 to
