G4-304SD1
User Manual & Install Guide
93 of 149
Channel 3 – set name as – CH3
Channel 4 – set name as – CH4
Channel 5 – set name as – CH5
Enable
Checkbox – if selected, enables this channel for
inclusion into the main stream recording.
DEFAULT SETTINGS:
For channels 1 to 5, only enable the channels
which actually have cameras connected. Please
note that the system will show a videoloss
message on channels which are enabled, but
do not have a connected camera (i.e., no
incoming video stream).
Resolution
Drop list for selecting the resolution to record
the video on this channel (applicable to
channels 1 to 4 ):
CIF (352x240)
WCIF (464x240)
HD1 (704x240)
WHD1 (928x240)
D1 (704x480)
WD1 (928x480)
For the Digital IP Camera, 5, the drop list
contents will change to reflect the supported
resolutions of the currently attached IP camera.
Most commonly, these will typically be:
720P (1280x720)
DEFAULT SETTINGS:
For channels 1 to 4 (analog camera channels),
set the following:
D1
For channelXXX 5 (IP camera channel), set the
following:
720P
Frame Rate
Drop list allowing you to select the frame rate
(in terms of frames per second) that you would
like to record at.
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
