G4-304SD1
User Manual & Install Guide
139 of 149
Installation Guidelines
Please note the following:
The device must be secured to an interior surface of the vehicle using the Tek Screws provided.
Wire the device into the vehicle according to the Quick Reference Guide and the appropriate
cabling diagram.
DO NOT disassemble the device. There are no user serviceable parts inside.
Configuration Guidelines
The device firmware must be configured before using the G4-304SD1.
Use either an ICD2 or Monitor/Finger Mouse combination to access the setup menu.
Enter the following login information when prompted:
User name : admin
Password : admin
You can also use the ICD2’s touch screen to perform these tasks starting with the Menu button.
Move the cursor to the Setup icon and press Enter.
Navigate to Surveillance>Record>Mainstream to setup the analog channels (one through four).
To set up IP Channel navigate to Surveillance>IPC Setup.
To set Vehicle ID, navigate to Basic Setup>Regist Info>Vehicle Info.
After setting the configurations, with the SD Card inserted, access the Setup menu. Navigate to
Setup>Maintenance>Storage to format the SD Card.
Please note: non-Gatekeeper branded SD cards may not function reliably. If used, non-
Gatekeeper branded SD cards must be formatted in the G4-304SD1 prior to use.
Start vehicle, and wait for recorder to boot up (approximately two minutes). Confirm live camera
video is visible on monitor (small Green camera in each camera image – indicates the G4-
304SD1 is recording).
Confirm G4-304SD1 is recording by observing the LED’s as per the following table.
Record Mode
Safe To Remove SD Card
LED
COLOR
Flashing Status
LED
COLOR
Flashing Status
PWR Blue
Constant On
PWR
Blue
Off
REC
Green
Constant On
REC
Green
Off
USB
Green
Constant On
USB
Green
Off
ERR
Orange
Constant On
ERR
Orange
Off
ALM Red
Constant On
ALM
Red
Off
NET
Green
Constant On
NET
Green
Off
Note: The NET status LED is currently not supported.
To access the SD Card turn key to unlocked position, and unclip the side retainer panel.
