03. Hardwired Installation
Step 1.
Switch mode.
To be able to work with Hardwired Installation, necessarily go to chapter 04.
(Programming Card usage, p. 18) and switch mode to MODIFIED WIRING.
STOCK WIRING
MODIFIED WIRING
SEMI
AUTO
SEMI
BURST
BURST
AUTO
SEMI
AUTO
SEMI
BURST
Step 2.
Adapt AEG installation.
To adapt the standard AEG installation to work with
WARFET
Power Module you
have to get to the trigger contacts. In case of GB v2 contacts are located inside
a gearbox. With a version 3 gearbox, installation is easier because the contacts are
on the outside of the gearbox. Please consult a local airsoft technician if you have
never disassembled a gearbox before or if you have any installation concerns.
A
B
Fig 1. – Standard AEG wiring scheme
BATTERY
UP TO 14.8V
AEG Motor
CONTACTS
Using this method, the original wiring is kept intact, and the connections are
modified. Referencing Fig 1., de-solder A wire from the one of the trigger contacts
and then solder it to the B wire. It does not matter which wire you disconnect from
the trigger switches, just join the two wires together at one terminal. In the place of
the A wire, solder the additional single trigger wire (No. 6 – provided in the kit).
a) Installation of
WARFET
Power Module without replacement of wires
USER GUIDE
16
WWW.GATEE.EU
WARFET
FUSE
