Battery charging
LEDs on control box and battery
• Connect plug to 230V wall socket. Charging begins auto-
matically and the battery LED flashes green.
• Make sure the battery is fully charged before using for the
first time. It takes around
25 h to fully charge the battery.
• We recommend that the battery plug be removed from the
control box if the product will be out of use for an exten-
ded period (more than one week) or if the battery is swit-
ched off by means of the ON/OFF switch. This eliminates
the risk of disabling the battery as the control box always
uses a small quantity of electricity even when the walker is
not in use.
• Control box – green light when power is available from bat-
tery/mains socket.
• Battery:
• The LED flashes green during
charging.
• ON/OFF: To use the product,
press ON.
• The green lamp will begin to flash.
• Use the OFF button (hold down for 5 s) to switch off the
battery if the product will not be used for an extended
period.
• The LED will shows a constant green light when the battery
is fully charged.
• When the battery is in normal state/in operation, the LED
• flashes green at REGULAR intervals, namely 0.5 s ON, 4 s
OFF.
• When the battery requires charging (remaining charge
<25%) the LED will flash
• orange/red at REGULAR intervals, namely 0.5 s ON, 4 s
OFF.
NOTE!
The battery has an in-built device that automatically
switches it off when remaining charge is <20%. The LED is
then extinguished. The battery must now be fully charged
before the electronics can be used again.
