REVISION 2019-2
GateMotors: +44 (0)1202 744958 • Technical support: +44 (0)1202 725489
www.gatemotors.co.uk • Sales and Accessories: +44 (0)1202 717191
Fix the pivot bracket
T1
onto the pillar by welding or bolting (
O
/
13 mm bolts
), making sure the measurements shown
in the previous table are met. Ensure to keep a minimum distance of
30 mm
from the pillar edge as shown (pic H).
In cases of masonry pillars, use chemical or resin to secure the bolts into position. Brackets
T1
are supplied in two
versions, left hand and right hand and match the according motor (see picture I). Fix the motor to bracket
T1
and place
the pivot pin
PR1
through the holes. Keep the pivot pin
PR1
oriented downward (pic J).
Fixing pillar bracket T1
Gates fixed on the edge/corner of a pillar
In this case the gate can be opened up to
120°
. To achieve this, measurement
A
must
be equal to or greater than measurement
B
(pic F).
Based on the figures shown on the previous page (Table A) – Ideally measurement
B
(Pic F) will be
decreased
by the same amount as the
A
measurement is
increased
.
For example: If installing the myAster 3Ti – measurement
A
increasing
20 mm
(now
170 mm) means measurement
B
ideally decreases
20 mm
(now 130 mm).
Typical gate mounting for swing gates
Gate hinged in the centre of the pillar
Gate hinged on the corner of the pillar
Pillar
Gate leaf
Gate leaf
Pillar
Fig. A
Fig. B
Min. 30 mm
T1 Left
T1 Right
PR1
G1
(pic H)
(pic I)
(pic J)
Outward opening
• In the case of an outward opening gate, the gate
motor must be positioned on the inside face of
the gate pillar (pic G).
• In this case the measurement
A
(distance between
the axis of the hinges and the rotation axis of the
motor) has to be measured towards the centre of
the gate, and it is necessary to modify the bracket
T1
to adapt it to the new fixing position (pic G).
• In order to not reduce the size of the passage, the
motor can be positioned in the upper part of the
gate, at a height no less than
2000 mm
.
• You can find the position of the front bracket with
the method indicated above, but with the leaf of
the gate open.
• The preferred measurements are the same as
those shown on the previous page (Table A).
• All fastenings must be strong and secure.
(pic G)
(pic F)
OUTWARD FACING
INWARD FACING
INSIDE
FACE
IN
SI
D
E FA
C
E
