- Setting is possible within the range of 0 ~ 20(%) by using "UP" S/W나 "DOWN" S/W.
- If "FUNC" S/W is pushed when the desired value is displayed, the selection is set and the next
-
item is entered into.
- When "RESET" S/W is pushed, Option Setting Mode is returned to.
- Item for setting of Emergency Time Out. Status of time setting can be determined upon checkup
-
Mode.
- When "FUNC" S/W is pushed, the setting function for Emergency Time Out is entered into.
- When "RESET" S/W is pushed, Option Setting Mode is returned to.
- ON/OFF state can be set by using "UP" S/W나 "DOWN" S/W. In the case of ON, checkup Mode
time is operated for 30 min, while check mode time continues to be operated without restriction
in the case of OFF.(Initial value OFF)
- If "FUNC" S/W is pushed when the desired item is displayed, the selection is set and the next
item is entered into.
- When "RESET" S/W is pushed, Option Setting Mode is returned to.
- The message informing completion of setting function is displayed as "End" for 2 sec, and the
-
display state of gas concentration is returned to.
www.gastron.com
28
_
29
GTC-520A
Instruction Manual
- For display of the measured value, display unprocessed data from -XXXX to +YYYY.
- When "FUNC" S/W is pushed. The setting function for "Under" is entered into.
- When "RESET" S/W is pushed, Option Setting Mode is returned to.
-
(This Mode is used only as Test mode, and is not used in actual fields)
- ON/OFF state can be set by using "UP" S/W or "DOWN" S/W, where the function can be used in
the case of ON.(Initial value OFF)
- If "FUNC" S/W is pushed when the desired item is displayed, the selection is set and the next
item is entered into.
- When "RESET" S/W is pushed, Option Setting Mode is returned to.
- Item for setting of Zero Skip.
- The value corresponding to the setting range for High scale is subject to zero skip.
- When "FUNC" S/W is pushed, the setting function for "S-S" is entered into.
- When "RESET" S/W is pushed, Option Setting Mode is returned to.
- Setting is possible within the range of 0 ~ 20(%) by using "UP" S/W or "DOWN" S/W.
- If "FUNC" S/W is pushed when the desired value is displayed, the selection is set and the next
item is entered into.
- When "RESET" S/W is pushed, Option Setting Mode is returned to.
- Item for setting of Span Skip.
- Span skip the value corresponding to the setting range for High scale.
- When "FUNC" S/W is pushed, the setting function for "Eto" is entered into.
- When "RESET" S/W is pushed, Option Setting Mode is returned to.
▼ ▲
▼ ▲
6. How to operate
6. How to operate
