• Only install the appliance in proper form secure grounding receptacle with adequate
electric power supply (alternating current; 230/240 V, 50 Hz) and ground fault circuit interrupter.
The maximum power consumption of the appliance is 1000 Watt. You should also install a fuse
with a release current of maximum 30mA. If necessary ask your electrician for help.
•
Never
pull, rip, bend, clamp, squish or knot the line cord. Pay attention to the line cord not
hanging of the table. Attend to nobody getting caught in loops of the line cord or pulling the
appliance of the work space. When pulling the plug always catch hold of the enclosure of
the plug.
•
Carry the appliance with both hands by the motor block – never by the filling pan or the
mincer.
•
The mincer must only be used to process meat and vegetables. Do not mince hard parts
such as bones. Do not mince hard-fibre foods such as ginger, etc. Do not let the motor run
longer then necessary to prevent overheating. After turning OFF the appliance the motor
needs about 6 sec. to stop moving.
• Clean the appliance straight after use and rinse off leftover food. Remove such dirt immediately
and operate according to the instructions ´Care and cleaning` before storing the appliance. Do not
let food desiccate on the appliance.
•
Never
clean or operate the appliance or units of the appliance with abrasive or hard
sharp-edged items.
Never put the appliance or parts of the appliance in the
dishwasher for cleaning! This will cause discoloration and corrosion.
•
Do not use the appliance if it is damaged or units of the appliance are damaged. Do not
use the appliance if it does not function properly or if it was excessively loaded. The appliance
is likely damaged if the appliance or units of the appliance show cracks, exorbitant wearing
down, alterations or leaks. It is also likely damaged if the drive wheel of the motorblock moves
slowly. Take the appliance for technical maintenance and repair to an authorised
specialised reparation shop.
•
Never
use force assembling or disassembling the appliance. The single parts should be
easily put together. Only operate the mincer after it has been carefully assembled.
Never
use the crossed-blade knife and mincer plate in combination with the chopper attachments.
Only use either the crossed-blade knife with the mince plate or the chopper attachments at
once.
•
For the case that the mincer head or the closing ring loosen while operating turn OFF the
appliance immediately and pull the plug. Operate according to the instructions ´Trouble
shooting` before turning the appliance ON again.
• Always turn the appliance off, wait for the motor to stop moving and then pull the plug
before disassembling the mincer.
22
41402_Manual_Neu.qxp 20.12.2006 11:42 Seite 22
