EN
44
5. Ensure that the exterior of the kettle is dry. Then place the kettle onto the power
base and connect the appliance to the power supply. A beep sounds and the
display is illuminated, showing the actual water temperature or two dashes, if
the water temperature is below 30°C. The appliance is now ready for operation
(standby mode).
WARNING
–
Risk of Scalds:
The exterior of the kettle will get hot during
operation. Only touch the kettle at the operating elements and handle. Even with
the lid closed properly, hot steam could escape from under the lid during operati-
on and some minutes thereafter. Do not hold your face, hands, or other parts of
your body, or any delicate objects over or directly beside the kettle, if the kettle is
still hot.
NOTE
The kettle is no measuring appliance. There may be differences between the tem-
perature displayed on the display and the actual temperature of the water. Addi-
tionally, after heating the actual water temperature may be somewhat higher than
the set temperature. Take this into consideration, especially when setting low tem-
peratures and heating small amounts of water.
6. Set the desired temperature by pressing the temperature selection button shortly
several times until the desired temperature will flash on the display. You can set
the desired temperature from 50°C to 100°C (boiling) in steps of 5°C.
NOTE
If you wish to heat up to the same set temperature as last time, you can start the
heating cycle without any settings. The appliance will always keep the recently
used temperature in memory. Additionally, you may use the shortcuts for setting the
temperature: 100°C (hold the KEEP WARM button pressed for 2 seconds), 80°C
(hold the temperature selection button and KEEP WARM button pressed simultane-
ously for 2 seconds), or 60°C (hold the temperature selection button pressed for 2
seconds). See also: ‘Properties of Your Water Kettle’.
7. Simply press the ON/OFF button to start the heating cycle. The kettle will start
heating immediately. On the display, the actual water temperature will be
shown.
8. If you wish to use the keep warm function, shortly press the KEEP WARM button.
You may activate or de-activate the keep warm function during operation just as
you like.
9. As soon as the water reaches the set temperature, the kettle will switch to the next
step automatically. With the keep warm function activated, the ON/OFF button
